User manual WHIRLPOOL DDB 5810/IN INSTRUCTION FOR USE

[. . . ] WARNUNG: Schalten Sie das Stromnetz am Hauptschalter ab, bevor Sie den Anschluss der Abzugshaube vornehmen. WARNUNG: Prfen Sie, ob das Abluftrohr und die Befestigungsmanschetten im Lieferumfang inbegriffen sind. Andernfalls sind diese separat zu beziehen. bezeichneten Teile sind Zubehr, das nur mit bestimmten Modellen oder gar nicht geliefert wird und gesondert erworben werden muss. [. . . ] AVVERTENZA: Verificare se il tubo di scarico e le fascette di fissaggio sono forniti a corredo. In caso contrario, vanno acquistati a parte. Nota: I particolari contrassegnati con il simbolo ?(*)?sono accessori opzionali forniti solo in alcuni modelli o particolari non forniti, da acquistare. AVVERTENZA: Prodotto dal peso eccessivo, la movimentazione e installazione della cappa deve essere fatta da almeno due o pi persone. GR ????????????????. 5019 318 33292 ? 5019 318 33292 Fig. 1 Material supplied Remove all the components from the packets. Check that all the components are included. Hood assembled with motor and lamps installed. 2 - screws 3 x 9 mm 5019 318 33292 D GB F NL E P I GR SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with the local regulations for disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. [. . . ] Note: Drill all the holes indicated on the template: the top 2 holes are for hanging the hood and the bottom holes are for fixing it securely to the wall. (Fig. 1) to the wall and against the ceiling. Use the support bracket as drilling template (if present, the small slot on the support must match the line drawn on the wall) and mark 2 holes with the pencil, drill the holes and finally insert 2 plugs. Fix the flue support bracket to the wall with 2 screws. [. . . ]