User manual WHIRLPOOL DDTI 5950 IN COOKERHO INSTRUCTION FOR USE

[. . . ] The side of the truss with connection box corresponds to the side of the control panel with hood assembled. Insert and tighten another 2 screws in the remaining free holes for secure fixing. Carry out the electrical connection to the mains power supply, only turn on the power supply with assembly completed. Extractor Version: steam and fumes are exhausted to the outside through a discharge pipe fixed to the collar located on the top of the hood. [. . . ] Joint the two bottom sections of the flue: position the rear section first and connect up the light panel; then position the front section and connect the light panel and the controls. Fix the two bottom sections of the flue, using 6 screws (3 each side - also see the plan diagram for joining the two sections) plus 4 screws to fasten the flues to the structure (15 A). Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue (CAUTION!THE BOTTOM FLUE TABS ARE THE NARROWER AND SHALLOWER ONES. The wider and deeper tabs are those used for the top flue, and must be cut to size. Turn the mains power on again at the central electrical panel and check for correct hood operation. 5019 418 33074 D GB F NL E P I GR 41833074. fm Page 8 Monday, December 12, 2005 4:31 PM 5019 418 33074 D GB F NL E P I GR 41833074. fm Page 9 Monday, December 12, 2005 4:31 PM 5019 418 33074 D GB F NL E P I GR 41833074. fm Page 10 Monday, December 12, 2005 4:31 PM 5019 418 33074 D GB F NL E P I GR 41833074. fm Page 11 Monday, December 12, 2005 4:31 PM PRODUCT SHEET 1. 1 Press for 3 seconds to enable all functions (Stand-by - Led L1 on). Light ON/OFF button Press this to turn the lights on and off, even when the hood is in the OFF position. Press for one second to turn the courtesy light on; press again for one second to turn it off. Decrease speed button Press this button to decrease the speed from 4 to 1. Increase speed button Press this button to pass from stand-by to speeds 1, 2, 3 and 4. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Cleaning the hood Warning!Failure to remove oil and grease (at least once a month) could lead to fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials can be dangerous for children. Keep packaging materials (plastic bags, polystyrene, etc. ) well out of their reach. Make sure the hood has not been damaged during transport. Installation, electrical connections and replacement of the power cable with plug or flexible cable must be carried out by a qualified technician in compliance with the current local regulations. Declaration of conformity This product has been designed, manufactured and sold in conformity to the following standards: safety objectives of the “Low Voltage” Directive 73/23/EEC protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING! • • 1. Do not allow children or infirm persons to operate the appliance without supervision. Make sure children do not play with the appliance. Do not connect the appliance to the mains electricity supply until installation is completed. [. . . ] 4. 5. Electrical connections Before calling the After-sales Service 1. Check if you can fix the problem yourself (see "Troubleshooting guide"). Switch the hood off and then on again to check if the problem has gone. If the problem persists, contact the After-sales Service. [. . . ]