User manual WHIRLPOOL DF 5260 WS INSTRUCTION FOR USE

[. . . ] 4 Never leave the pan unattended when frying since the cooking oil could ignite. Regular maintenance guarantees smooth hood operation and high performance. If the hood is used together with non-electrically powered appliances, ambient negative pressure must not exceed 4 pa (4 x 10-5 bar). For this reason, make sure the room is well ventilated. [. . . ] Pull out the steam deflector (depending on model). Turn the speed selector to the required speed setting according to the quantity of fumes and steam to be extracted. Switch off the hood 5 minutes after you have finished cooking. Close the steam deflector (where fitted). Care and maintenance Always disconnect the hood by switching off the electrical power supply before cleaning or carrying out maintenance. Grease filter • The sponge grease filter should be washed in hot soapy water once a month (soak for 1-2 hours, do not wring. Replace with a new filter every 5-6 washes). • The grease filter paper should be replaced at least once a month. • Grease filter paper with indicator should be replaced at least every two months or whenever the colour becomes visible through the holes of the grille. The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter is installed. Specify: • The nature of the problem. • The service code (number below the word SERVICE on the rating plate inside the hood behind the grease filter). • • Your full address. Your telephone number and area code. Installation When installing the hood, the minimum distances from the cooktop must be respected, and the numerical sequence and additional instructions must be followed exactly as indicated on the Installation sheet. Some models are fitted with a plastic deflector that closes off the rear outlet. Put the cover (if fitted) in the upper outlet. If the hood has a carbon filter, this should be removed. Check that the switch inside the hood (if fitted) is in position“A” Extractor; if not, set it to this position. Electrical connection Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your home. The plate is located inside the hood behind the grille. For GB this appliance is supplied without a plug and is intended for direct connection to fixed wiring in accordance with national wiring regulations. An all-pole disconnection switch with a minimum contact separation of 3 mm must be included in the fixed wiring in an easily accessible position. [. . . ] An all-pole disconnection switch with a minimum contact separation of 3 mm must be included in the fixed wiring in an easily accessible position. The Manufacturer shall not be liable for any damage or problem arising from the failure to comply with the above-mentioned instructions. External Exhaust Mode ( - see also installation sheet) Cooking fumes and vapours are conveyed outside through a duct connected to the hood by means of a collar. The outlet duct diameter must be the same as that of the collar. If a flue-damper is to be installed, check that it can open and close freely when installation of the exhaust duct is complete. [. . . ]