User manual WHIRLPOOL DF6038W2VV PRODUCT FICHE

[. . . ] All safety warnings give specific details of the potential danger/warning present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions: • Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. € The appliance must be disconnected from the power supply before carrying out any installation work. [. . . ] This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. sAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). IMPORTANT: In order to avoid product damages, do not spray cleaners directly to the control while cleaning the Hood. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. gB10 MAINTENANCE IMPORTANT: - use protective gloves. - disconnect the appliance from the power supply. GREASE FILTERS Metal grease filters have an unlimited life and should be cleaned once a month by hand or in a dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause discolouring of the grease filter, but its filtering efficiency is unaffected. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit it. lIGHTING SYSTEM The hood lighting system is based on LED technology. The LEDs ensure optimum lighting and last up to ten times longer than conventional lamps but with 90% less energy consumption. Contact the after-sales service for replacement. [. . . ] The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, the suitability of the materials for the type of wall/ceiling must be checked by a qualified technician. iNSTALLATION DIMENSIONS Adjacent wall units 900 mm min. Centre line 65 cm (gas or combi cookers) 45 cm (electric cookers) Adjacent wall units hob surface GB12 INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the drawings (giving the same numbering) on the last pages of this manual. [. . . ]