User manual WHIRLPOOL DKM 1393 IN INSTRUCTION FOR USE

[. . . ] Remove the grease filters and fix the hood from inside using 2 screws and washers. depending on hood version: Extractor Version: Fix an exhaust duct with the right diameter to the exhaust outlet of the hood and connect to an exhaust system ducted to the outside (for fixture and connection of exhaust duct, utilize the most suitable system for the duct purchased). Filter Version Install the filter connection F on the collar B and secure with 1 screw. • Connect the hood to the power supply! [. . . ] Remove the clip that secures the lamp cover, then prise off using a small screwdriver or other suitable tool. Refit the lamp cover and secure in place with the clip. Note: the lamp can also be accessed by removing the grease filters, but removing the lamp in this way is more difficult. 2 4 1. Light : move the switch to the right or press the button to switch on. Extraction speed : Move the switch to the right or press the next button to increase extraction speed (or open the electric shutter ) . Grease filter (the number of grease filters may vary, depending on the model). Lamp covers (the number and position of lamps and/or lamp covers may vary, depending on the model). Air vent (Filter version only) Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. Removing the filter: push the spring release handle backwards (b) then remove the filter downwards (a). Wash the filter and leave it to dry, proceeding in reverse order to refit it. b Carbon filters (filter hoods only): Change the carbon filter every four months. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated. Exhaust air must not be conveyed through the same flue used by the heating system or other appliances powered by gas or other fuels. The room must be adequately ventilated when the hood is used together with appliances powered by gas or other fuels. Make sure lamps are cold before touching them. The discharge air must not be ducted to a flue used for removing fumes produced by appliances using gas or other fuels, but must have a separate outlet. All national regulations on air discharge must be observed. The hood is not a shelf, therefore do not overload or place objects on it Note: Always wear work gloves for all installation and maintenance operations. • To ensure best use of your hood, please read these instructions carefully and keep them for future reference. [. . . ] Make sure the hood has not been damaged during transport. Declaration of conformity This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide The hood does not work: • Is the plug properly inserted in the power socket?The hood is not extracting sufficiently: • Is the right speed selected?• Do the filters need cleaning or changing?The light does not work: • Does the lamp need replacing? [. . . ]