User manual WHIRLPOOL DML 5360/SG INSTRUCTION FOR USE

[. . . ] Fix to the wall units with the screws supplied (18). Position the spacer according to the depth of the wall unit and tighten the 2 screws (19-20). Apply the exhaust hose (21) and fix it with a clamp (hose and clamp are not provided). Refit the steam deflector (22), hooking it by operating the special side tabs (23). [. . . ] Extractor Version: Fumes are extracted and expelled to the outside through a fume hose fixed to the collar at the top of the hood. The discharge air must not be ducted to a flue used for removing fumes produced by appliances using gas or other fuels, but must have a separate outlet. All the national regulations on air discharge must be observed. 5019 418 33098 D GB F NL E P I GR PRODUCT SHEET CONTROL PANEL A. Filter or grille release devices. FIG. 4 Grease filter - it can be one of the following types: Paper filter: to be replaced once a month or, if the top part is coloured, when the colour shows through the holes in the grille. Metal filter: to be washed once a month by hand or in a dishwasher with quick wash cycle at low temperature. The metal filter may become opaque over time; this does not affect its filtering capacity. FIG. 5 Removing and renewing or washing the grease filter: Unplug the appliance or disconnect the power supply. Open the grille or grease filters (2, 3 - Fig. For hood version with grille: Remove the device securing the grease filter (Fig. After the grease filter has been replaced or cleaned (depending on model), refit the parts in reverse order, making sure the entire extraction surface is covered. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. If the hood is used together with other appliances powered by gas or other fuels, ambient negative pressure must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated. Exhaust air must not be conveyed through the same flue used by the heating system or other appliances powered by gas or other fuels. The room must be adequately ventilated when the hood is used together with appliances powered by gas or other fuels. Make sure lamps are cold before touching them. Exhaust air must not be conveyed through a flue used for removal of fumes produced by gas combustion appliances or other combustible materials, but must have an independent outlet. All national regulations governing extraction of fumes must be observed. The hood is not a shelf, therefore do not overload or place objects on it. [. . . ] Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Note: Always wear work gloves for all installation and maintenance operations. • This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE as amended) - protection requirements of the “EMC” Directive 89/336/CEE amended by Directive 93/68/CEE. Troubleshooting guide The hood does not work: • Is the plug properly inserted in the power socket?The hood is not extracting enough: • Is the right speed selected? [. . . ]