User manual WHIRLPOOL DNHI 5455 SG INSTRUCTION FOR USE

[. . . ] To fix the hood, proceed as follows: Position the drilling template on the inside right wall of the wall unit, with the arrow pointing towards the back of the wall unit (FIG. Drill as indicated on the template (FIG. Repeat the procedure on the left hand side of the wall unit (FIG. B-5) and secure it to the wall unit using the 4 screws provided (FIG. [. . . ] Close the lighting unit. REPLACING BULBS: Replacing the fluorescent lamp: Fig. 1 4. REMOVING AND REPLACING OR CLEANING THE GREASE FILTER: 1. After the grease filter has been renewed or cleaned (depending on model), remount in reverse order, making sure the entire extraction surface is covered. Be sure to use a mild detergent when washing the filter. If the carbon filter is already fitted and needs renewing, press the release buttons (e - fig. locate the carbon filter under the top clips (fig. secure in place with the bottom clips (fig. Some models are provided with a round carbon filter: to fit, insert the filter into its housing so that it covers the plastic grille, then turn it in a clockwise direction until it locks into place. To remove, proceed in reverse order(fig. 2 FITTING OR REPLACING THE CARBON FILTER: 1. 4 5019 418 33072 D GB F NL E P I GR 41833072. fm Page 8 Friday, October 7, 2005 6:09 PM SAFEGUARDINGTHE ENVIRONMENT 1. Packaging Packaging materials are 100% recyclable and are marked with the recycling symbol . Dispose of the appliance in conformity with local environmental regulations. Packaging materials can be dangerous for children. Keep packaging materials (plastic bags, polystyrene, etc. ) well out of their reach. Appliance This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the appliance or accompanying documentation indicates that this product should not be disposed of as unsorted municipal waste but must be taken to a collection point for the treatment of WEEE. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Cleaning the hood Warning!Failure to remove oil and grease at least once a month could lead to fire. Use a soft cloth damped in a neutral detergent. Never use abrasives or alcohol. Before using the hood Please read these instructions carefully in order to get the best out of your new hood. [. . . ] Specify: • the nature of the problem, • the model of hood, stated on the data plate inside the hood, accessible by removing the grease filters. • your full address, • your telephone number and area code. • the service code (the number appearing below the word SERVICE on the data plate inside the hood behind the grease filter). If any repairs are needed, contact an authorised Service Centre (to ensure that only original spare parts are used and that repairs are made correctly). [. . . ]