User manual WHIRLPOOL DP168BL PRODUCT FICHE

[. . . ] All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Slowly open dishwasher door while someone grasps the rear of the dishwasher. remove shipping materials , drain hose and lower rack. Prepare dishwasher and faucet for use as specified in these instructions. [. . . ] The dishwasher must be installed to meet all electrical and plumbing national and local codes and ordinances. Tip Over Hazard Do not use dishwasher until completely installed. Doing so can result in serious injury or cuts. Read and follow the instructions provided with any tools listed here. A hot water line with 20-120 psi (138-862 kPa) water pressure can be verified by a licensed plumber. Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70 - latest edition and all local codes and ordinances. A copy of the above code standards can be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, MA 02269 You must have: · Make sure all these parts were included in the parts bag. See parts list for accessories available for your dishwasher. 6 cm) high and not higher than 48'' (122 cm) from the bottom of dishwasher. ⷠFloor support for dishwasher weight of 180 lbs (81. NOTE: Make sure the hoses are not kinked or twisted. Use the faucet adapter kit that came with your portable dishwasher to modify the faucet where the dishwasher will be used. NOTE: Remove and save the washer, screen, and screen holder or aerator for future use. Pull down on the locking collar while lifting the hose connector onto the faucet adapter. Insert the 2 screens and then the thin washer from the faucet adapter kit into the faucet adapter. When the connector snaps into place, release the locking collar. Turn the hot water on slowly until it is all the way on. Failure to follow these instructions can result in death, fire, or electrical shock. Lift slightly on the hose connector while pulling down the locking collar. Empty any remaining water from the connector by turning the connector upside down. [. . . ] Empty any remaining water from the connector by turning the connector upside down. Unplug the power supply cord and return it to the storage compartment. You can draw water from the faucet while the dishwasher is connected. NOTE: Do not draw water while the dishwasher is filling or while water is being pumped out. [. . . ]