User manual WHIRLPOOL DPA 311/G GEBRUIKSAANWIJZING

[. . . ] normally soiled blouses , shirts , overalls etc. Made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. curtains and delicate clothing , dresses skirts , shirts and blouses. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. [. . . ] Programme Duration (hours : minutes)* 2:00 2:20 2:00 1:30 1:15 0:45 0:30 0:45 0:40 0:36 PROGRAMME START Open the tap and press the “Start (Pause)” button. The indication lamp next to the “Start (Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finished, the corresponding indication goes out. €œDOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. cHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start (Pause)” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. [. . . ] SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. unsuitable combinations of options are deselected automatically. €œHalf load” button • Reduces water consumption, above all during rinsing. [. . . ]