User manual WHIRLPOOL DSTI 5410 IN/PT PROGRAM CHART

[. . . ] WARNUNG: Schalten Sie das Stromnetz am Hauptschalter ab, bevor Sie den Anschluss der Abzugshaube vornehmen. WARNUNG: Prfen Sie, ob das Abluftrohr und die Befestigungsmanschetten im Lieferumfang inbegriffen sind. Andernfalls sind sie separat zu beziehen. bezeichneten Teile sind Zubehr, das nur mit bestimmten Modellen oder gar nicht geliefert wird und gesondert erworben werden muss. [. . . ] To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Adjust the extension of the hood support structure, as the final height of the hood depends on this. Note: In some cases the support structure is fixed to the motor assembly with 1 or more screws. Check for and temporarily remove any screws to enable adjustment of the support structure. Fix the two sections of the structure using 16 screws (4 each corner). Note: If required; insert the reinforcement bracket in the truss and position it over the motor assembly. The bracket must only be refitted in place after fixing the truss to the ceiling. Place the ceiling hole diagram directly above the cooktop (the centre of the diagram must match the centre of the cooktop and the edges must be parallel to the sides of the cooktop - the side of the diagram with the wording FRONT corresponds to the control panel side) Prepare the electrical connection. Drill as shown (6 holes for 6 wall plugs) and insert the 6 wall plugs in the holes drilled, screw the 4 outer screws shown in the diagram, leaving a space of about 1 cm between the screw head and the ceiling. Fit an exhaust pipe inside the truss and connect it to the collar of the motor compartment (exhaust pipe and clamps are not provided). For filter operation (10F), fit the deflector F on the truss and fix it to the bracket with 4 screws. Finally, connect the exhaust pipe to the collar located on the deflector. [. . . ] Carbon Filter excluded: the filter alarm is disabled. Enabling/ Disabling the Acoustic Signal The acoustic signals can be activated or disactivated by pressing the ?Light?When the acoustic signal is activated, a tone is emitted and the symbol ?Snd?When the acoustic signal is disactivated, the symbol ?Snd? [. . . ]