User manual WHIRLPOOL DTLG 9010 INSTRUCTION FOR USE

[. . . ] IMPORTANT INSTRUCTIONS FOR SAFETY YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the alert symbol, relevant to safety, which warns of potential risks to the user and others. All safety messages will be preceded by the alert symbol and the following terms: DANGER WARNING Indicates a hazardous situation which, if not avoided, will cause serious injury. [. . . ] (Figure 4) The hood stops during operation Make sure: • • There is not a power failure. The differential thermal-magnetic switch (safety cutout) has not tripped. 2 The lamp does not work • • Check if the lamp needs replacing. Make sure the lamp is correctly fitted. Fig. 4 GB14 AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service. Always specify: • A brief description of the fault; • The exact type and model of the appliance; • The service number (number after the word "Service" on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • Your full address; • Your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). CLEANING WARNING - Do not use steam cleaners. - Disconnect the appliance from the power supply. IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters, checking correct installation and hooking, otherwise the hood will not switch on. IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it immediately with a damp cloth. • Clean the surfaces with a damp cloth. If very dirty, add a few drops of washing up detergent to the water. Dry with a dry cloth. IMPORTANT: Do not use abrasive sponges, metallic scrapers or scouring pads, as they could eventually spoil the enamelled surfaces. • Use specific detergents for cleaning the appliance and follow the manufacturer's instructions. IMPORTANT: Clean the filters at least monthly to remove any oil or grease residuals. IMPORTANT: Failure to carry out correct hood cleaning or filter maintenance involves the risk of fire. Therefore make sure to follow the instructions. The manufacturer declines any liability for damage to the extraction unit, fires caused by improper maintenance or failure to observe the above instructions. GB15 MAINTENANCE WARNING - Use protective gloves. - Disconnect the appliance from the power supply. IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters, checking correct installation and hooking, otherwise the hood will not switch on. GREASE FILTER Its purpose is to retain the particles of grease produced by cooking. [. . . ] • extraction speed (power) 2: 15 minutes. • extraction speed (power) 3: 10 minutes. • extraction speed (power) 4: 5 minutes. Fig. 14 Press button T2 or T3 and the hood exits timed mode and the extraction speed (power) decreases or increases depending on the button pressed. [. . . ]