User manual WHIRLPOOL DW 2677/2 INSTRUCTION FOR USE

[. . . ] Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Refer to the dishwasher loading instructions. [. . . ] The last programme selected will light up. Press the button until the desired programme lights up. Load the racks Select a programme Select options If necessary (and if provided) the corresponding indicator lamp lights up. “Change programme” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Fold down glass holder (A): Depending on the position, for example small or long-stemmed glasses. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Use suitable glasses. • Not made of stainless steel. • The START indicator lamp flashes. • Use suitable cutlery. [. . . ] • The START indicator lamp flashes. • Use suitable cutlery. • Ensure that the filter assembly is not clogged and if necessary clean it *. Press the Start button for 2 seconds, until the Start indicator lamp switches off. [. . . ]