User manual WHIRLPOOL DWER 2780 IN INSTRUCTION FOR USE

[. . . ] • Do not pull the power supply cable in order to unplug the appliance. • The electrical components must not be accessible to the user after installation. • Do not touch the appliance with any wet part of the body and do not operate it when barefoot. • The appliance is not intended for use by persons (including children) with any physical, sensory or mental impairment, or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. [. . . ] Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. ELECTRICAL CONNECTION Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F 3 x 0, 75 mm2) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place after installation. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules. GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing iThe packing material is 100% recyclable and is marked with the recycle symbol and in full compliance with local authority regulations governing waste disposal. Scrapping the product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. The various parts of the packing must therefore be disposed of responsibly GB9 TROUBLESHOOTING GUIDE The appliance does not work: • Check for the presence of mains electrical power and if the appliance is connected to the electrical supply. • Turn off the appliance and restart it to see if the fault persists. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary: • Check that the filters are clean: • Check the air vents for any obstructions. The light does not work; • Check the light bulb and replace if necessary; • Check that the light bulb has been correctly fitted; AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service. Always specify: • A brief description of the fault; • The exact type and model of the appliance; • The service number (number after the word "Service" on the rating plate), located on the inside of the appliance. [. . . ] The hood comes with all the materials necessary for installation on the majority walls/ceilings. However, a qualified technician must ensure that the materials are suitable according to the type of wall/ceiling. INSTALLATION DIMENSIONS Adjacent wall units 630 mm min (55cm wide model) 880 mm min (80cm wide model) Adjacent wall units centre line 65 cm (gas or combi cookers) 50 cm (electric cookers) hob surface GB12 INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. IMPORTANT: The hood comes in filter version. The carbon filter is supplied and must be fitted after installation (as shown in fig. 12). [. . . ]