User manual WHIRLPOOL DWF 445 W (900 270 43) PROGRAM CHART

[. . . ] Start delay indicator blinks and the count-down is running by reducing the time in one hour steps. The count-down is indicated by the blinking of the start-delay indicator located above the button. During count-down the drum will turn from time to time to redistribute the laundry. The pump may be heard working for a short time. [. . . ] Press gentle button Do not tumble dry B) By amount and thickness/weight Whenever the load to be dried exceeds dryer capacity, separate laundry according to weight (e. g. C) By type of fabrics Cotton/linen: towels, cotton jersey, bed and table linen made of cotton or linen. Synthetics/Easy Care: blouses, shirts, overalls, etc. made of polyester or polyamide, as well as cotton/synthetic mixes. D) By drying level • Sort into: iron dry, cupboard dry, etc. Do not tumble dry: woollens, silk, nylon stockings, delicate embroidery, fabrics with metallic decorations, bulky items such as sleeping bags, etc. Important: only use specific indicated dryer-safe additives and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Only use specific indicated dryer-safe plastic items and never dry rubber or articles contaminated with vegetable oil in the dryer SELECTING A PROGRAMME & OPTIONS Programme and Options: • To select a programme, turn the programme selector knob. The Start/ Pause indicator lamp is blinking, indicating that the cycle needs to be started. • To select an option, press the corresponding button. The indicator lamp above the button confirms that a selection has been made. • Press the button again to cancel the option. DAILY MAINTENANCE & CLEANING Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. Push the filter back into place. AFTER-SALES SERVICE If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee). Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. • Your full address and phone number. TROUBLESHOOTING GUIDE If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected?• Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)?• Is the lint filter dirty (filter indicator lamp on)?The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start button). • Is the plug properly inserted into the mains electricity socket?• Has the start-delay option been selected? [. . . ] On completion of the programme, set the programme selector knob to position “0”. CHANGING A PROGRAMME When changing the programme during the drying cycle, the dryer stops. The Start/Pause indicator lamp is blinking. To operate the new programme, press the Start/Pause button again. INTERRUPTING A PROGRAMME To interrupt the dryer during operation 1. Set the programme selector knob to Airing. [. . . ]