User manual WHIRLPOOL DWF 447 W INSTALLATION

[. . . ] • If a fault occurs, switch off the appliance and turn off the water tap. • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it since the appliance may topple over. • If necessary, the power cable may be replaced with one the same obtained from our After-Sales Service. [. . . ] Before using the dishwasher for the first time, fill the rinse aid dispenser. Thereafter, regularly check the rinse aid level. Only use rinse aids recommended for use in domestic dishwashers. Open the rinse aid dispenser by turning knob A counter-clockwise (see diagram) and pulling it out. Fill with rinse-aid until the visual indicator B turns dark. Immediately wipe away any spilt rinse aid (from metal parts as well) to prevent excess suds which may spoil washing results. Rinse aid level indicator light = empty dark = full. How to adjust the rinse aid dosage regulator. (Open the cover and close again following adjustment). If you are not satisfied with washing or drying results, change the dial setting with a spoon handle or coin. If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use detergents in pellet form, follow the manufacturer’s directions for use. Always use the recommended dosage stated on the detergent pack. • Do not use the dishwasher if it has been damaged in transit. Consult your local retailer or our After-Sales Service. • The power cable must only be replaced by a qualified technician. 84 CONNECTIONS 1) ELECTRICAL CONNECTIONS “Warning - this appliance must be earthed” This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket. 2 pin with side earth contact) The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour. 3) FUSE REPLACEMENT If the mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug, replace the fuse only with an A. S. T. A. approved type conforming to BS 1362 and proceed as follows: 2) CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) To fit a new plug, proceed as follows: 2. 1 Polarized Plugs (e. g. 3 pin, 13 amp plug conforming to BS 1363A) a. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured yellow or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. [. . . ] • Have you used the correct amount of detergent?• Filters clogged or incorrectly assembled?• Spray arms blocked or nozzles clogged?(the water jets must spray the entire surface of all items). [. . . ]