User manual WHIRLPOOL DWH C10 W INSTRUCTION FOR USE

[. . . ] Press the button until the desired programme lights up. If necessary (and if provided) the corresponding indicator lamp lights up. “Change programme in progress” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Load the racks Select a programme Select options Press the Start button The selected programme is then memorised (even in the event of power failure). Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). [. . . ] until the Start indicator lamp switches off; Select another programme and press the START button again. Load the racks Select a programme Select options Press the Start button The selected programme is then memorised (even in the event of power failure). Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: press the OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Fold down glass holder (A): Depending on the position, for example small or long-stemmed glasses. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. Rack height adjustment (also when loaded): Lower adjustment: Pull the two rack handles (C) outwards and lower the rack. Pull the two rack handles (C) upwards until the rack clicks into place (factory setting). Upper adjustment: The rack must be level on both sides. Lower rack: Plate holders (D) foldable. Cutlery basket (E): The grid (F) can be fitted onto the cutlery basket to keep items separate. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. (if provided). • Use suitable cutlery. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault. • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! DWH C10 W Quick Reference Guide GB On button Options 3) “Half load” button The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme. [. . . ] • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! DWH C10 W Quick Reference Guide GB On button Options 3) “Half load” button The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme. The “Half Load” function can be used with programmes marked with an *. Off button Programme selection button Start button Switches “on” when the dishwasher is operating. [. . . ]