User manual WHIRLPOOL ED2KHAXV

[. . . ] If you should experience a problem not covered in TROUBLESHOOTING, please visit our website at www. If you still need assistance, call us at 1-800-253-1301. You will need your model and serial number located on the inside wall of the refrigerator compartment. Your safety and the safety of others are very important. [. . . ] " Your ice maker can produce both crushed and cubed ice. Before dispensing ice, select which type of ice you prefer by pressing the ICE button. To turn on the ice maker, slide the control to the ON (left) position. To manually turn off the ice maker, slide the control to the OFF (right) position. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position. REMEMBER: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The quality of your ice will be only as good as the quality of the water supplied to your ice maker. avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained. Do not use anything sharp to break up the ice in the storage bin. This can cause damage to the ice container and the dispenser mechanism. Do not store anything on top of or in the ice maker or storage bin. The water filter status light will help you know when to change your water filter. When the water filter status display changes from "GOOD" to "ORDER, " this tells you that it is almost time to change the water filter cartridge. Replace the water filter cartridge when the water filter status display changes to "REPLACE. " If water flow to your water dispenser or ice maker decreases noticeably, change the filter sooner. The filter should be replaced at least every 6 months depending on your water quality and usage. After changing the water filter, reset the status light by pressing and holding the FILTER button for 3 seconds. The status light will change from "REPLACE" to "GOOD" when the system is reset. [. . . ] Outside the 50 United States and Canada, this limited warranty does not apply. Proof of original purchase date is required to obtain service under this limited warranty. iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. [. . . ]