User manual WHIRLPOOL EGN 5800 IN INSTALLATION

[. . . ] After the oven has been installed, the electrical components must be inaccessible. • • • • • ELECTRICAL CONNECTION See separate installation instructions supplied with the cooktop. Electrical connection between different models of hobs and oven Attention: The figures represent the right hand section of the oven, seen from the top, with the observer standing in front of the oven door. • Put clamp “B” into the first holes of junction block “C” starting from the left (as shown). • Connect the earth wire (D) of the cooktop to the oven (E) as illustrated. B C B C B C • Mount the corresponding knobs in the control panel last . . 4 gas burners hob: position of the knobs in the front controls hob 3 gas burners/1 electric hot plate hob: position of the knobs in the front controls hob Glass ceramic hob: position of the knobs in the front controls hob 14 Glass ceramic hob (with 2 double cooking zones): position of the knobs in the front controls hob BEFORE USING THE OVEN • To make the most of your new oven, read the users instructions carefully and keep them on hand for consultation in the future. [. . . ] If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. . PRECAUTIONS AND GENERAL RECOMMENDATIONS • Before any maintenance on the oven disconnect it from the electrical power supply. Keep children away from the oven when they are in use. The oven must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the oven do not come into contact with hot parts and do not become entrapped in the oven door. Use oven gloves to remove baking trays and accessories when the oven is hot. Do not cover the bottom of the oven with aluminium foil. Do not place inflammable material in the oven - risk of fire if the oven is inadvertently switches on Declaration of conformity • These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. The appliances are designed, built and sold in compliance with: The safety requirements of “Low Voltage” Directive 73/23/EEC. Wash the accessories in a dishwasher or in the sink, using an oven cleaner. After the oven has been in prolonged use and when cooking on different levels (especially food with high water contents such as pizzas, stuffed vegetables, etc. . . ) condensate may form on the inside of the door seal. When the oven is cool, dry any condensate with a cloth or sponge . • • • • • • 18 CLEANING THE OVEN AND ACCESSORIES Removing the oven door (for cleaning) 1. Lift the catches until they engage and then remove the door. Warning: While you are cleaning the oven, ensure you do not disengage the hinge retainer catches. Refit the oven door by following the above steps in reverse order. Dropping the grill element to clean the oven roof (depending on model) • Do not attempt to clean the oven until it is cool. To clean the oven roof, pull out the grill element and lower it as far as it will go. Clean the oven roof and then return the grill element to its original position. Disconnect the oven from electrical supply. Changing the lateral lamp (depending on model) Disconnect the oven from electrical supply. [. . . ] 5. . TROUBLESHOOTING GUIDE Oven not working • Switch the oven off and then on again to see if the problem persists. • Check for the presence of mains electrical power. • • Oven selector on position “0”, ?Check whether you have made the temperature setting and the function setting. [. . . ]