User manual WHIRLPOOL EK 3460 SW INSTRUCTION FOR USE

[. . . ] With heavily soiled laundry the additional “Prewash” option can be additionally selected. Slightly to normally soiled textiles made of cotton and/or synthetics. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens labelled with the woolmark and identified as machine washable. [. . . ] Programme Duration (hours : minutes)* 2:00 2:10 2:20 2:00 1:30 1:15 1:29 0:45 1:00 0:30 0:45 0:40 0:36 “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay” option. • Select programme, temperature and options. • Press the “Start delay” button to select the delay time by 1 to 23 hours. • Press the “Start” button. The countdown of the delay time begins; the “Start delay” indication lamp and the dot on the display will keep blinking until the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start” button, the number of hours preselected can be reduced by pressing again the “Start delay” button. Press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start” indication lamp blinks. The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. [. . . ] • Increases the water quantity and the clothes are spun very gently. “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without pregressing to the final spin cycle to avoid creasing and prevent colours from changing. [. . . ]