User manual WHIRLPOOL EKB 3482/2481 INSTRUCTION FOR USE

[. . . ] TABLE OF CONTENTS DESCRIPTION OF THE HOB BEFORE USING THE HOB PRECAUTIONS AND GENERAL SUGGESTIONS HOW TO USE THE HOB COOKING HINTS ENERGY SAVING HINTS CLEANING AND MAINTENANCE AFTER-SALES SERVICE INSTALLATION ELECTRICAL CONNECTION PAGE 77 PAGE 79 PAGE 80 PAGE 82 PAGE 85 PAGE 86 PAGE 87 PAGE 88 PAGE 89 PAGE 99 To get full satisfaction from your glass ceramic hob, please read carefully your instruction manual and keep it at hand for ready reference. 76 DESCRIPTION OF THE HOB GLASS CERAMIC HOB WITH FRAME KU 947-1 1. Quick Star heater ø 180 mm, 1800W - 400V 2. Quick Star heater ø 180 mm, 1800W - 400V 3. Double radiant heater ø 210/120 mm, 2100/700W - 400V 4. [. . . ] Then you can choose the desired position. 83 HOW TO USE THE HOB WARMING ZONE TOUCH CONTROL (For mod. EKA 3482-1 li and EKA 3482-1 re) Cooking Zone/Platt’s heating zone On the glass ceramic hob, there is four cooking zones and one for platt’s heating. Each cooking zone is provided with an energy control on your oven front panel or on the separate built-in control panel to turn ON/OFF and regulate the temperature for the cooking zone and on the glass ceramic panel there is an electronic touch button to turn ON/OFF your platt’s heating zone. The operations of the controls on the oven and on the built-in control panel are explained in the instructions manual supplied with the built-in oven or the built-in control panel. How to operate the sensitive touch control buttons for the platt’s heating zone The buttons are on the front side of the platt’s heater zone. To turn ON the heater, proceed as follow: - push button A shown as symbol - make sure that the red LED is turned ON (A1) - immediately after, maximum 5 seconds, push button B with the symbol I , the B1 LED will turn ON and the first LED will turn OFF. As long as LED B1 is ON that means that your heater is still ON. - To turn OFF the heater, push on button C with symbol . We recommend to always maintain dry the sensors zone to avoid any interference in the electronics controlling the heater which might turn OFF your heater. When installing the ceramic hob with the platt’s heater zone on the left, make sure that the installation is flush with the built-in oven or switch box on the right. When installing the ceramic hob with the platt’s heater zone on the right, make sure that the installation is flush with the built-in oven or switch box on the left. 84 COOKING HINTS Display position 12 10 10-11 10 9-10 9-10 8-9 8-9 7-8 7-8 5-6 6-7 4-5 5-6 3-4 4-5 2-3 3-4 1-2 2-3 1 1 0 0 Suitable for the following cooking To boil water, cook “gnocchi”, soup To fry potatoes and meat ex. goulash To fry croquettes, filet, tender loin, cordon bleu To roast beefsteaks, chops, meat-balls, fishcakes, browned onions To roast liver, eggs, croquette To boil potatoes and stews To cook vegetables and meat stews Flesh and fish To prepare rice-milk To heat already cooked food For cream sauces, to melt butter, chocolate, jellies Position “OFF”. 85 ENERGY SAVING HINTS 1. The pans base must be the same or slightly greater than that of the cooking zone never smaller. You can set a lower power and save energy. Pressure pans help to save energy and are quicker than traditional pans. !NO 86 CLEANING AND MAINTENANCE 1. Use clean clothes or paper for domestic use, liquid detergent, commercial products such as Sidol for stainless steel, Stahlfix or Cerafix or the enclosed razor-blade scraper. Do not use abrasive powder or detergent, oven sprays, rust or stain removers, bleaches, sponges with a rough abrasive surface, steelwood pads. Try to clean the hob when it is only slightly soiled, ideally after each use when it is lukewarm or cold. Encrusted food or fats are better removed while still warm, using the glass scraper supplied or razor blade. Finish cleaning with Sidol for stainless steel or Stahlfix. Should any sugar fall on the hob, remove it immediately as it may melt when it comes in contact with the hot surface of the hob. 87 AFTER-SALES SERVICE You have bought a high quality hob, manufactured according to the most advanced technologies. In case of faults, please check if you have followed all the instructions and hints given in this booklet. [. . . ] Remove again the glass ceramic hob and screw tightly the screws of flat eccentric roller. With a cleaning agent, clean properly the border of the hob to remove any oil grease or other dirt. Reinstall the glass ceramic hob in its hole and adjust the spacing around the glass to be evenly spaced on all sides. Press on the glass, particularly on the angles in order to evenly position the glass with the working table around it Fig. [. . . ]