User manual WHIRLPOOL EKD 5470-1 IN INSTRUCTION FOR USE

[. . . ] Important In order to prevent the electronic circuits from overheating, and therefore from being damaged, we recommend the following: 12 4gb61461. fm5 Page 13 Thursday, September 27, 2001 9:44 AM Installation Assembly A) If the worktop is made of wood, use the supplied spring clips and screws. • Position the 4 clips (A) as shown and at the specified distance. • Secure the clips using the 4 screws (B). • Fit the cooktop in the prepared worktop (see figure) B) If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc. ), the cooktop must be fitted by means of brackets code 4819 404 78697 (to be requested from the After-Sales Service). [. . . ] • After the electrical connection, fit the hob from the top and hook it to the support springs, according to the illustration. The appliance must be connected to the electricity supply by means of an allpole disconnect switch with minimum contact gap of 3 mm. 14 4gb61461. fm5 Page 15 Thursday, September 27, 2001 9:44 AM Energy saving tips • • • Use pots and pans whose bottom diameter is equal to that of the cooking zone. If possible, keep the pot covered when cooking. • • Cook vegetables, potatoes, et. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. NO! Protecting the environment 1. Packing • The packaging material can be100% recycled, as confirmed by the recycling symbol ( ). Products • The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. The appliances are designed, built and sold in compliance with: The safety requirements of “Low Voltage” Directive 73/ 23/EEC. The protection requirements of EMC Directive 89/336/EEC “Electromagnetic compatibility”. The requirement of Directive 93/68/EEC. • • • Declaration of conformity CE • These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. • 15 4gb61461. fm5 Page 16 Thursday, September 27, 2001 9:44 AM Precautions and general recommendations • Before any maintenance on the appliance disconnect it from the electrical power supply. Keep children away from the appliances when they are in use and when its has just been switched off. The appliances must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. Do not switch on the hotplates/cooking zones when there is no pan in position. • The cooktop features different size hotplates/ cooking zones. Use pans whose base diameter is the same as the diameter of the hotplate/cooking zone. To avoid permanently damaging the glassceramic top, do not use: - Pots with bottoms that are not perfectly flat; - metal pots with enamelled bottom. Do not use the cooktop as a work surface or a support surface. [. . . ] Set the main disconnect switch upline of the appliance to “OFF” for a few minutes and then back to “ON” and see if the problem persists. After Sales Service Before contacting After Sales Service 1. Try to solve the problem (see “Troubleshooting Guide”). Turn off the appliance and restart it to see if the fault is repeated. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. [. . . ]