User manual WHIRLPOOL EKI 4472 IN PROGRAM CHART

[. . . ] • If the appliance is damaged, do not use it, but unplug it from the mains and contact After-sales Service. • The glass ceramic hob has good mechanical resistance and is designed to withstand minor accidents and incorrect usage; however, if an object falls on it and damages the surface, do not use the hob. Disconnect it from the electrical power supply and call the nearest After- sales Service. • Do not use the hob as a work surface. [. . . ] • Avoid scratching the surface of the hob with the bottom of pots and pans. • To obtain the best cooking results, it is advisable to use flatbottomed stainless steel pots and pans. The diameter of the bottom must be equal to that of the hotplate or slightly greater. • Take steps to prevent sugar and other sugary ingredients such as jam, jelly and juice, from coming into contact with the hotplates. If you do have a spill, clean the hob thoroughly right away, following the cleaning instructions. • If the hob is fitted with halogen lamps, do not stare at them. 15 41966023aGB. fm Page 16 Friday, February 25, 2005 5:11 PM USING THE HOB The hotplates are clearly marked on the hob. The hotplates are switched on, adjusted and switched off again by turning the knobs on the oven in a clockwise direction. Next to the 4 knobs are numbers from 0 to 12 or 10. Each number corresponds to a power output level for cooking. The hob features 4 luminous residual heat indicators; these light up to indicate that the temperature of the hotplates is still high. The residual heat indicators light up as soon as the hotplates reach a temperature high enough to cause burns. Should any sugar spill onto the hob, clean it up immediately, otherwise it will melt on the hot surface of the hob. HOB ACCESSORIES Child guard accessory AMH 122 This accessory can be obtained from the After-Sales Service under Part N° 4819 310 18436. 18 41966023aGB. fm Page 19 Friday, February 25, 2005 5:11 PM TROUBLESHOOTING GUIDE The hob does not work: - Check for the presence of mains electrical power. - Switch the hob off and then back on again, to see if the problem has been solved. - Check that the knob is not turned to “0”. Set the all-pole disconnect switch to “Off“ for several minutes and then turn it back to “On“. AFTER-SALES SERVICE Before contacting After-Sales Service: • See if you can solve the problem yourself with the help of the suggestions given in chapter “Troubleshooting guide“. If after the above checks the fault persists, contact the nearest After-sales Service. Please give: • a brief description of the fault; • the type and exact model of the hob; • the service number (i. e. , the number that follows the word SERVICE on the rating plate, located under the hob) The service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. 19 41966023aGB. fm Page 20 Friday, February 25, 2005 5:11 PM INSTALLATION Important information This product has been designed, manufactured and marketed according to the following: - safety objectives of “Low Voltage” Directive 73/23/EEC; - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. The appliance has a type “Y” degree of protection against fire; it can therefore be placed against a wall higher than the worktop. DECLARATION OF CONFORMITY The components of this appliance conform to EEC Directive 89/109; and can therefore come into contact with foodstuffs. ELECTRICAL CONNECTION To be done before connection to the electricity supply. [. . . ] Fit the hob into the housing, as indicated by the manufacturer 2. Remove the drawer from the oven and push it into the housing unit so that the earth wire and connectors of the hob can be connected. For Oven-Hob connection, ensure the colours of connectors match. Unscrew the nut of the earth screw on the top cover of the oven and insert the yellow/green earth wire, leaving the washer in place. [. . . ]