User manual WHIRLPOOL EKS 3460-1 IN PROGRAM CHART

[. . . ] in this programme spinning is intensive. Same as the spin cycle in the “Coloured Cotton” programme. A very gentle spin is used in this programme. Same as the spin cycle in the “Wool” programme. [. . . ] In addition all running programmes can be cancelled with this programme. Afpompen / Reset – ❉ – – 1) 2) For improved garment care spin speed is restricted to 800 rpm in this programme. For improved garment care spin speed is restricted to 400 rpm in this programme. 5019 401 10007 CONSUMPTION DATA * Programme Temperature (°C) Cotton Coloured Cotton Coloured Cotton Synthetics Synthetics Delicate Wool Rapid wash Handwash 95 60 40 60 40 30 40 30 30 Load (kg) 5 , 0 5 , 0 5 , 0 2 , 5 2 , 5 1 , 5 1 , 0 3 , 0 1 , 0 Water (l) 44*** 39 39 55 50 50 50 35 35 Energy (kWh) 1 , 60 0 , 95 0 , 55 0 , 70 0 , 50 0 , 50 0 , 50 0 , 40 0 , 40 Programme duration ** approx. (hours : minutes) 1:55 2:00 2:00 1:30 1:15 0:45 0:40 0:30 0:35 “Easy Ironing” button • To lessen creasing, the water quantity is increased and the clothes are spun very gently at reduced power. This makes your laundry significantly damper at the end of the programme. START DELAY The “Start Delay” allows to run the machine at the consumer's convenience, for example at night when electricity is cheaper. • Press the “Start Delay” button. Select the programme start from 1 to 19 hours ahead by pressing the button again. • Press the “Start/Pause” button. The Start Delay indicator light flashes until the programme starts. Press the “Start/Pause” button again to restart the programme. € If you are in the “Prewash” programme step this additional option can not be deselected as described (to do this see “Cancel/Delete Programme). Press the “Start/Pause” button to interrupt the programme. The spin speed “0” and the remaining time “2 minutes” are displayed. Press the “Start/Pause” button to start the “Drain/Cancel” programme. * Consumption values were measured in normalized conditions in compliance with Standard IEC 60456. ** The programme duration may also vary from the chart values. The washing machine is able to allow for particular household conditions and to adapt the programme run time accordingly. *** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. POUR IN DETERGENT, CLOSE THE DOOR AND SELECT A PROGRAMME Add the detergent as described in the chapter “Detergent and Additives” in the booklet. Turn the programme selector knob in any direction to the desired programme. [. . . ] The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp above the “Start/Pause” button is flashing. The programme sequence indicator and the indicator with the maximum possible spin speed light up. The temperature can be altered by pressing the “+” or “-” button under the corresponding LED display. sELECT SPECIAL OPTIONS - The indicator lights go on. [. . . ]