User manual WHIRLPOOL EKV 3460 IN PROGRAM CHART

[. . . ] until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. [. . . ] Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. Carving forks, knives) must be arranged with the sharp end facing in towards the appliance. half Load: Load the upper rack (see description of Options). Place the cutlery basket (C), if provided, in the upper rack. Rack height adjustment (also when loaded): Pull the two rack handles (D) Lower adjustment: outwards and lower the rack. Pull the two rack handles (D) upwards until the rack clicks Upper adjustment: into place (factory setting). B A C D D Retainer open Retainer closed Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (E) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions!GSF 2990 Quick Reference Guide GB Programme selection button Options 3) Time and failure display Indicates in hours the time remaining until the start of the wash cycle. Switches off at programme start and indicates the remaining time in hours and minutes. € Information for the After-Sales Service On / Off button “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. start button Switches “on” when the dishwasher is operating. [. . . ] start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. €œHalf load - Multizone” button Load the upper or lower rack only. This function can be used with any programme. [. . . ]