User manual WHIRLPOOL EMZH 5964 IN INSTALLATION

[. . . ] • There must be nothing between the cooktop and the oven (e. g. cross rails, insulating material, etc. ). • An adjacent column unit must be installed at least 100 mm from the edge of the cooktop (fig. [. . . ] • The dimensions of the oven and unit are shown in figures 1-2-3. • To allow for proper ventilation, an opening should be left at the bottom of the housing unit. • Leave a minimum clearance of 5 mm between the upper edge of the oven and the lower edge of the worktop (fig. 2) This clearance must never be obstructed. • When installing, make sure that the sides of the oven do not touch the adjacent units. • If the kitchen unit is not securely fixed to the wall, it must be anchored with standard brackets (G) available on the market, see fig. 3. Glass-ceramic cooktop Important: Remove any protective film before installing the cooktop. Make sure that that the opening in the worktop for the cooktop is cut according to the dimensions given in the drawing on the Product Description Sheet. The cooktop should not be forced into the worktop. Forcing the glass-ceramic top may cause it to crack (even at a later date)! 3 10200153aGB. fm Page 4 Monday, September 5, 2005 3:27 PM • If the worktop is made of wood, use the spring clips and screws provided. 7) as shown, paying attention to the specified distances. • If the worktop is made of marble, plastic, ceramics, stone, etc. , the cooktop must be secured with special brackets (F) (fig. 8), Code 4819 404 78697, available from After Sales Service. Place the 4 brackets (F) in position in accordance with the thickness of the worktop as shown in fig. Fasten the 4 screws (G) in the positions (H) (fig. 8). Power supply cables table N° of conductors 1N+ 2 + 2N+ 3N+ 3 + Type of cable H05 RR-F 3 X 4 mm² H05 RR-F 3 X 4 mm² H05 RR-F 4 X 2. 5 mm² H05 RR-F 5 X 1. 5 mm² H05 RR-F 4 X 2. 5 mm² ~ ~ ~ ~ ~ Interconnecting cooktop and oven Important: do not connect the oven to the power supply before you have finished connecting the oven and cooktop. • Before connecting the oven to the power supply, make sure that the cooktop is among the ones listed in the cooktop/oven pairing product sheet provided. • Connect the two male 3 pole (H) (fig. [. . . ] • Observance of safety directives requires that a multi pole switch with a minimum contact gap of 3 mm be used for the installation. • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. [. . . ]