User manual WHIRLPOOL ESN 5460 BR INSTRUCTION FOR USE

[. . . ] • Cut an opening in the worktop of the dimensions shown on the Product Description Sheet provided with the worktop. • We recommend you seal the internal edges of the worktop with wood glue or silicone. • If not already in place, apply the supplied seal to the cooktop, after cleaning the adhesive surface thoroughly. [. . . ] • If the worktop is made of wood, use the spring clips and screws provided. 5) in their guides on the bottom of the cooktop. • If the worktop is made of marble or other material (plastic, ceramics, stone, etc. ), the cooktop must be secured with special brackets (C) (fig. 6), Code 4819 310 18528, (available as a complete set from After Sales Service). Fasten the brackets into the holes with the screws provided. Fit the cooktop into the worktop. Preparing the housing unit Built-under oven • Kitchen units in contact with the oven must be heat resistant (80 °C min). • Cut the kitchen unit and worktop to fit before installing the appliances. Carefully remove any shavings or sawdust that could prevent the appliances from running properly. • The dimensions of the oven and unit are shown in figures 1-2-3. • Connect the two male 3 pole (H) (fig. 9) connectors of the cooktop to the respective female connectors located on the right hand side of the top covering of the oven. • Unscrew the nut of the ground screw (K) (fig. 9) on the left hand side of the top covering of the oven and insert the yellow/green earth cable, leaving the washer in place. • Screw the nut back onto the screw and tighten it as far as it will go. Securing the oven • Lift the oven getting hold of it by the openings on the sides and insert it into the housing unit, being careful not to trap the power supply cable (fig. • Center the oven in the housing unit before securing it. • Make sure that the plastic spacers (if provided) are positioned correctly in the fastening holes. Then anchor the oven to the housing unit with the screws provided. Electrical connection • Regulations require that the appliance be earthed. [. . . ] • Connection to the mains must be carried out by a qualified electrician in accordance with the manufacturer's instructions and in compliance with local regulations. • The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. • The oven power cable must be long enough to connect the built-in appliance to the mains. [. . . ]