User manual WHIRLPOOL ESZ 4466/01 IN INSTRUCTION FOR USE

[. . . ] Instructions for use Precautions and general recommendations Installation Electrical connection Energy saving tips Oven accessories Cooktop accessories Cooking charts Cleaning the oven and accessories Cleaning the cooktop Troubleshooting guide After Sales-Service Precautions and general recommendations Before using the appliances • To make the most of your new appliances, read the users instructions carefully and keep them on hand for consultation in the future. • Remove the cardboard protections and the protective plastic film. • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of protective grease and insulating materials. Keep the window open during this procedure. [. . . ] • If the cooktop is to be installed next to a column unit, leave a distance of at least 100mm from the edge Cooktop with electric hotplates • If the worktop is made of wood, fit the supplied clips. 1. Position the 4 spring clips (B) and fit them in their locations on the underside of the cooktop. • If the worktop is made of marble, plastic, ceramics, natural stone, etc. , the cooktop must be secured with brackets (C) code 4819 310 18528 (to be requested from After Sales Service). 1. Position the brackets over the holes and secure them with the supplied screws. of the cooktop to the side of the column unit. • Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately. • If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure. Installation Glass-ceramic cooktop N. B. : Remove the protective film before installing the cooktop. • If the worktop is made of wood, use the supplied spring clips and screws. 1. Position the 4 clips (D) as shown and at the specified dimensions. • If the worktop is made of marble, plastic, ceramics, natural stone, etc. , the cooktop must be secured with brackets (F) code 4819 404 78697 (to be requested from After Sales Service). 2. Position the 4 brackets (F) as shown in the figure, in accordance with the thickness of the worktop. 3. Fix the 4 screws (G) in holes (H). Electrical connection • Make sure the appliances are installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • The installer is responsible for the correct electrical connection of the appliances and the observance of the relative safety regulations. • The appliance must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. • The appliances must be earthed by law. Conductors x numbers 1N+ 2N+ 3+ 3N+ • Do not use multiple plug adapters or extension leads. • After the appliances have been installed, the electrical components must be inaccessible. WARNING: DO NOT CONNECT TO THE POWER SUPPLY BEFORE YOU HAVE FINISHED CONNECTING THE OVEN AND COOKTOP. • Mount the oven in the kitchen unit. Make sure the power cord is not trapped. Connecting the oven to the power supply • Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. E The rating plate is on the front edge of the oven cavity (visible with oven door open). • Use a type H05RR-F power cord (minimum length 800 mm). [. . . ] • Do not leave acidic substances on the cooktop (vinegar, salt, lemon juice, etc. ). Stainless steel cooktop • Use a proprietary cleaning product for stainless steel. N. B: Prolonged use of the cooktop may result in slight discoloration of the stainless steel surfaces around the hotplates. This is caused by the high temperature of the hotplates. [. . . ]