User manual WHIRLPOOL ESZ 5464 BR INSTRUCTION FOR USE

[. . . ] Do not touch the heating elements in the oven. • This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. • Any repairs or servicing must be carried out exclusively by a qualified technician. [. . . ] • If alcoholic beverages are added when roasting or cooking cakes and sweets (for example, rum, cognac, wine, etc. ) remember that alcohol evaporates at high temperatures. It may happen that vapours released by the alcohol can catch fire when they are in contact with the electric heating element. • Do not heat sealed containers in the oven (except for packages specifically designed for this purpose; see the manufacturer’s instructions). The pressure that develops inside the packaging might cause it to explode, damaging the oven. • Do not use containers made of synthetic material for cooking (except for packages specifically designed for this purpose; see the manufacturer’s instructions). • Keep an eye on the oven if you are using a lot of fat or oil. Oil and fat can overheat and catch fire!Use extreme caution. BEFORE USING THE OVEN • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of the protective grease and insulating materials. Keep the window open during this operation. • Before using the oven, remove: - stickers on the front and oven door, except for the rating plate; - cardboard protection and protective plastic film from the front panel controls and other parts of the oven; - any sticky labels from the accessories (for example, under the drip tray). 13 41056112aGB. fm Page 14 Wednesday, May 31, 2006 7:28 PM OVEN ACCESSORIES Accessories supplied depend on the model. The accessories provided with the oven are listed in the Product Description Sheet provided separately (under Accessories). Drip tray (1) The drip tray is designed to collect fat and food particles when it is positioned under the grid or as a plate, such as when cooking meat, chicken and fish with or without vegetables. • At the end of the cycle and when the oven has cooled, use a damp sponge to remove any food residues. • Never clean the self-cleaning catalytic panels and rear cavity with abrasive products, rough brushes, pan scourers, or oven cleaner sprays, as they will lose their automatic cleaning properties. 15 Accessories • Soak the accessories in water with washing up detergent immediately after use. Food residues can be easily removed using a brush or sponge. 41056112aGB. fm Page 16 Wednesday, May 31, 2006 7:28 PM Attention: When carrying out the following operations it is advisable to wear protective gloves. These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. Lift the two catches and push them forwards as far as they go (see fig. Remove the door by closing it partially and pulling it upwards (see fig. Insert the hinges into their grooves and lower the door fully. Attention: These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. 1 2 3 To lower the grill heating element (certain models only) Do not attempt to clean the oven until it is cool. • Pull (4) the grill heating element slightly forward and lower it (5). 4 5 16 41056112aGB. fm Page 17 Wednesday, May 31, 2006 7:28 PM Changing the rear oven lamp bulb (if provided): 1. Disconnect the oven from the electrical supply. [. . . ] Important: Do not use the oven until the lamp cover has been repositioned. 3 4 17 41056112aGB. fm Page 18 Wednesday, May 31, 2006 7:28 PM TROUBLESHOOTING GUIDE Oven not working: • Check for the presence of mains electrical power and if the oven is connected to the electrical supply. • Turn off the oven and restart it to see if the fault persists. IMPORTANT: • Check that the oven control knob is not turned to “0” or to the “lamp” symbol . - If the electronic programmer (depending on model) display presents the message “ ”, consult the product description sheet provided separately and/or the electronic programmer description. [. . . ]