User manual WHIRLPOOL ETI 6646 NE/1 INSTRUCTION FOR USE

[. . . ] 10 IMPORTANT SAFETY INFORMATION This manual contains important information regarding safety, the use and maintenance of your new hob. Read the manual carefully and keep it in an easily accessible place for future consultation. thermoprotector activates , automatically switching off the hob. The display shows an error message (see. [. . . ] For the distance between the underside of the induction hob and the kitchen unit (or separating panel), observe the dimensions given in the figure at the side. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. Position the clips (A) in the spaces provided on the hob trim (fig. Measure the centre point of the vertical sides of the cut-out (fig. Fit the brackets (C) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with the worktop surface (fig. Fix the brackets with the 4 screws supplied (B) using the holes provided. Insert the hob in the cutout, making sure the clips (A) are secured in the spaces provided (fig. 4 Undercounter oven installation: • If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. € There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. 5 mm OPERATING INSTRUCTIONS Control panel Timer On/Off Child safety the symbols are not active!To select the desired functions, touch the areas below. Cooking zone controls and corresponding display Switching the hob ON/OFF To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. The hob automatically switches off if no function is selected within 10 seconds of switching on. 14 Switching on and adjusting cooking zones Heat setting indicator Button Cooking zone positioning Button + Selected cooking zone indicator After switching on the hob and positioning the pot on the chosen cooking zone, adjust the heat setting using the button +. When switched on, the display shows level 5. Each cooking zone has different heat settings that can be adjusted using the buttons +/-, which go from “1”: min. Some cooking zones have a fast boil function (Booster), shown on the display with the letter “P”. Fast boil function (Booster) This function, only present on some cooking zones, makes it possible to exploit the hob's maximum power (for example to bring water to the boil very quickly). To select this function, press the button “+” until “P” appears on the display or, after switching the hob on, press the “-” button for the selected cooking zone. [. . . ] after-sales Service Before contacting After-sales Service: • Try to solve the problem (see “Troubleshooting Guide”). € Switch the appliance off, wait 30 seconds then switch it on again. If after the above checks the fault persists, contact the nearest After-sales Service. Always provide: • a brief description of the fault; • the exact type and model; • the service number (number after the word Service on the rating plate) is located on the underside of the cooktop or on the warranty booklet; • your complete address and phone number. [. . . ]