User manual WHIRLPOOL ETI 6740/IN INSTRUCTION FOR USE

[. . . ] 41902022GB. fm Page 11 Monday, June 23, 2008 12:39 PM IMPORTANT SAFETY INFORMATION This manual contains important information regarding safety, the use and maintenance of your new hob. Read the manual carefully and keep it in an easily accessible place for future consultation. thermoprotector activates, automatically switching off the hob. The display shows an error message (see. [. . . ] Clean the cutout of any chips that could compromise appliance operation. 770 510 +1 0 510 +1 0 483 553 min. 8 +2 0 490 560 490 +2 0 750 For flush mounted installation or setting into a marble worktop, contact the After-sales Service for the installation kit and necessary instructions. • 4812 310 19277 Installation kit for marble worktop. • 4801 211 00112 Installation kit for flush fitted worktop. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any remaining dust that could compromise appliance operation. For the distance between the underside of the induction hob and the kitchen unit (or separating panel), observe the dimensions given in the figure at the side. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. min. Position the clips (A) in the spaces provided on the hob trim (fig. Measure the centre point of the vertical sides of the cut-out (fig. Fit the brackets (C) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with the worktop surface (fig. Fix the brackets with the 4 screws supplied (B) using the holes provided. Insert the hob in the cutout, making sure the clips (A) are secured in the spaces provided (fig. 2 13 41902022GB. fm Page 14 Monday, June 23, 2008 12:39 PM A fig. 4 Undercounter oven installation: • If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. • There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. ). 5 mm OPERATING INSTRUCTIONS Control panel Timer On/Off Child safety the symbols are not active!To select the desired functions, touch the areas below. Cooking zone controls and corresponding display Switching the hob ON/OFF To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. All the cooking zones are switched off. If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. The hob automatically switches off if no function is selected within 10 seconds of switching on. 14 41902022GB. fm Page 15 Monday, June 23, 2008 12:39 PM Switching on and adjusting cooking zones Heat setting indicator Button Cooking zone positioning Button + Selected cooking zone indicator After switching on the hob and positioning the pot on the chosen cooking zone, adjust the heat setting using the button +. [. . . ] Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed using a scraper for glass. Glass scrapers have a very sharp blade and must be handled with care. Remove any stubborn food residues with a scraper or proprietary detergents. Salt, sugar and sand can scratch the glass ceramic hob: clean up any such spills on the hob immediately. Troubleshooting Guide • Before contacting After-sales Service: • read and follow the instructions given in the section “Operating instructions”. [. . . ]