User manual WHIRLPOOL ETIH 5660 NE/01 INSTRUCTION FOR USE

[. . . ] clips and screws. B) If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc. ), the cooktop must be fitted by means of brackets code 4819 404 78697 (to be requested from the After-Sales Service). • • Position the cooktop into the prepared worktop. Position the 3 brackets (C) as shown in the figure, in accordance with the thickness of the worktop. Secure the three screws (E) in the holes (D). • 13 41963004GB. fm Page 14 Wednesday, February 1, 2006 12:23 PM Electrical connection Electrical connection must be made before connecting the appliance to the electricity supply. [. . . ] This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Declaration of conformity CE • 2. Products • • • • • • These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. The appliances are designed, built and sold in compliance with: The safety requirements of “Low Voltage” Directive 73/23/EEC. The protection requirements of EMC Directive 89/ 336/EEC “Electromagnetic compatibility”. The requirement of Directive 93/68/EEC. 15 41963004GB. fm Page 16 Wednesday, February 1, 2006 12:23 PM Precautions and general recommendations • • • • Before any maintenance on the appliance disconnect it from the electrical power supply. Keep children away from the appliances when they are in use and when its has just been switched off. The appliances must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. • • • • • • Do not use the cooktop as a work surface or a support surface. Do not leave the appliance unattended when frying food -risk of fire. If the glass ceramic surface should break or crack due to violent impact (falling objects, etc. . . ) do not use it and call After-Sales Service immediately. Do not place food wrapped in aluminium foil, plastic containers or cloths on the hot cooking zones. Do not drag pans across the glass-ceramic surface risk of scratches. Avoid spilling sugar and similar substances on the cooktop. If necessary, clean the cooktop immediately following the care and maintenance instructions in this handbook. [. . . ] - To solve the problem, follow the instructions in the section “Cleaning and maintenance of the glass ceramic cooking hob”. If the cooktop does not work following intensive use, the cooktop internal temperature is too high. Wait a few minutes until the cooktop cools down. Important! If you are not able to turn the glass ceramic hob off after using it, disconnect it immediately from the power supply. After Sales Service Before contacting After Sales Service 1. Try to solve the problem (see “Troubleshooting Guide”). [. . . ]