User manual WHIRLPOOL ETII 5640 NE/01 INSTRUCTION FOR USE

[. . . ] The 4 cooking zone displays show “0”. If within 20 seconds none of the cooking zones is activated, the hob switches off automatically as a safety precaution. Press one of the buttons “B” corresponding to the cooking zone you intend to use. [. . . ] Select the heat setting required with buttons “B” or “C”. Press buttons +/- at the same time to cancel all settings. IMPORTANT: The control is deactivated 10 seconds after the heat setting has been selected. To change the heat setting, first press the selection button “B” again, then proceed to change the setting, using buttons “B” or “C”. The CHILD SAFETY function is switched on by holding down button “E” until a dot lights up above the function button. The Child Safety function locks all the hob's other functions, with the exception of the On/Off button “A”. This function remains on even after the hob has been switched off and on again. The FAST BOIL function switches the highest power setting on to bring water to the boil rapidly. To select this function, first select the desired cooking zone using buttons “B” and then press button “D”: the display will show the letter P. The Fast Boil function can be used with all cooking zones. The Fast Boil function can only be used simultaneously with two cooking zones, one of the left and one on the right. Warning: Depending on the heat setting selected, when this function is used together with the other hotplate on the same side of the hob, hob operation will be somewhat noisy. A With the AUTOMATIC BOOSTER function, the cooking zone reaches the selected heat setting more rapidly. To select this function, first select heat setting “9” and then press button “B”. When the display shows the letter “A”, turn the heat setting down to the desired level for cooking (using button C). [. . . ] When the display shows the letter “A”, turn the heat setting down to the desired level for cooking (using button C). The letter “A” flashes at the selected level. Upon reaching the desired heat setting, the “A” disappears from the display, which shows only the selected heat setting (1-9). [. . . ]