User manual WHIRLPOOL ETII 5740 IN PROGRAM CHART

[. . . ] 1 • Measure the centre of the vertical sides of the cut out a shown in Fig. • Position the centre of the brackets (C) on the centre of the side previously identified. • The upper edge of the brackets must be flush with the worktop surface. • Secure by means of the 4 screws (B) provided, using the pre-drilled holes. [. . . ] • Close the terminal board with the cover (A) securing it with the screw provided. • After the electrical connection, fit the hob from the top and hook it to the support springs, following the diagram. Each time the hob is connected to the mains it carries out an automatic check which lasts several seconds. 15 41902016GB. fm Page 16 Wednesday, May 21, 2008 5:40 PM ENERGY SAVING TIPS • Use pots and pans whose bottom diameter is equal to that of the cooking zone or slightly larger. • Only use flat-bottomed pots and pans. • If possible, keep pot lids on when cooking. with little water in order to cut down cooking time. • A pressure cooker allows you to save even more energy and time. NO! TO OBTAIN THE BEST RESULTS: • Make sure you place the pot or pan in the centre of the cooking zone outlined on the glass ceramic induction hob. SAFEGUARDING THE ENVIRONMENT 1. Packing • The packaging material is 100% recyclable and marked with the recycling symbol ( ). Products This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. Use pots whose base diameter is the same as that of the hotplate/cooking zone. • Do not place metal objects such as knives, forks, spoons or lids on the hob surface since they can become very hot. To avoid permanently damaging the glass ceramic hob, do not use: - pots with bottoms that are not perfectly flat; - metal pots with enamelled bottom. • When finished cooking, press button . • Do not use the hob as a work surface or a support surface. • Do not leave the appliance unattended when frying food -risk of fire. • If the glass ceramic surface should break or crack to due violent impact (falling objects, etc. ), disconnect the appliance from the mains and contact After-sales Service immediately. • Do not place food wrapped in aluminium foil, plastic containers or cloths on the hot cooking zones. • Do not drag pans across the glass ceramic surface - risk of scratches. • Avoid spilling sugar and similar substances on the hob. When necessary, clean the hob immediately following the care and maintenance instructions in this handbook. [. . . ] - To solve the problem follow the instruction in the “Cleaning and maintenance of the glass ceramic hob paragraph”. If one of the following codes is displayed when the hob On button is pressed: ER22, ER25, ER31, ER36, ER47, E2, E5, E6, E7, E9 contact the After-sales Service and inform them of the code displayed. If the hob does not work following intensive use, the hob internal temperature is too high. Wait a few minutes until the hob cools down. [. . . ]