User manual WHIRLPOOL ETK 6260 IN PROGRAM CHART

[. . . ] Use the “+” and “-” keys (4) to adjust the heat level (from 1 to 9). Press and hold down these keys to increase or decrease the setting. The relevant cooking area must already be activated with relative decimal point (12) illuminated. Return the setting to “0” by means of the key “-” (4). [. . . ] Note that the timer function will also be deactivated. Using the timer as a minute counter When the timer function is not programmed, the timer display can be used simply to count down minutes (i. e. when the displayed time elapses, the cooking area is not deactivated). Setting the minute counter When the unit is OFF: 1. Use the “+” and “-” keys (4) to set the required time to be counted back. When the unit is ON and a cooking area is activated: 1. Deselect the zone by pressing the relative key (2); the decimal point (13) will go out. Set the time required by means of the “+” and “-” keys (4). Deactivating the minute counter function When the set time has elapsed, an acoustic signal is emitted for two minutes. To interrupt the timer, proceed as follows: 1. Press the “-” key to reset the time (4). Rapid deactivation of the minute counter PROTECTING THE ENVIRONMENT Disposal of packaging materials • • The packing material can all be fully recycled, as confirmed by the recycling symbol . Do not dispose of the various packaging materials carelessly, but do so responsibly and in full compliance with local authority regulations governing waste disposal. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. WARNINGS • If the glass ceramic surface should break or crack, refrain from using it and call the After-sales Service immediately. If the hob incorporates halogen cooking elements, do not stare at them. The hob is designed for use as a domestic food cooker only. The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls. [. . . ] • This cooking hob has been designed, constructed and marketed in compliance with: - safety objectives of “Low Voltage” Directive - 2006/95/EC (which replaces 73/23/EEC as amended). ; - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. • Glass ceramic hob Important: remove any protective film before installing the hob. Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range. ASSEMBLY: After having cleaned the perimeter surface, apply the supplied gasket to the hob as shown in the figure. [. . . ]