User manual WHIRLPOOL ETM 3410 SW PROGRAM CHART

[. . . ] - Ensure that the installation and maintenance are performed by a qualified technician, following the manufacturer's instructions and in compliance with current local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. - Regulations require that the appliance is earthed. - The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply. [. . . ] - Ensure pots have a smooth bottom, otherwise they may scratch the hob's glass ceramic surface. - Never place hot pots or pans on the hob's control panel. This could result in damage. RECOMMENDED DIAMETERS OF POT BOTTOMS XL Ø 30 cm Ø 24 cm Ø 18 cm Ø 14 cm Ø 17 cm Ø 14 cm 18 cm 24 cm L 30 cm XL Ø 28 cm Ø 21 cm Ø 14. 5 cm Max. Ø 18 cm 28. 5 x 18 cm 18 cm 28. 5 cm Min. Ø 16 cm 18 cm 14 cm (Dual zone) Ø 28 cm Ø 15 cm Ø 11 cm 14. 5 cm 21 cm L M S IMPORTANT: Refer to the “SENSOR” section for correct pan base diameters for cooking zones with SENSOR function. GB13 41901130. book Page 14 Thursday, September 10, 2009 12:01 PM INSTALLATION After unpacking the hob, check that there has been no damage during transport. If in doubt, contact the dealer or After-sales Service. PREPARING THE HOUSING UNIT WARNING - min. 5 mm Install a separator panel under the hob. The lower part of the product must not be accessible after installation. If there is an oven beneath the hob, do not install the seperator panel. min. 5 mm • • • For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure. Do not obstruct the minimum required clearance between the hob and the top of the unit to ensure the correct operation of the product. The hob automatically switches off if no function is selected within 10 seconds of switching on. If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message “no pot” will appear in the display (see figure on the left). If no pot is detected within 60 seconds, the hob switches off. To change the power level, move your finger horizontally on the slide touchscreen: the number inside the circle will change with just a quick slide of the finger from a minimum of 1 to a maximum of 9. You can activate the booster function by pressing “BOOST” on the slide touchscreen (“P” on the display). If more than one cooking zone is on, the slide touchscreen allows you to change the power level of the selected zone, indicated by the presence of a luminous dot at the bottom right of the power level indicator. To select a zone, simply press the relative round key. Switching off cooking zones Select the cooking zone to be switched off by pressing the relative round key (a dot lights up at the bottom right of the power level indicator). The cooking zone switches off and, if the zone is still hot, the letter “H” appears in the circle. “H” is the residual heat indicator. The hob is fitted with a residual heat indicator for each cooking zone; these indicators alert the user when cooking zones are still hot. When the cooking zone cools down, the display switches off. GB15 41901130. book Page 16 Thursday, September 10, 2009 12:01 PM Timer selection The timer can be used to set a max. [. . . ] IMPORTANT: do not use abrasive sponges or pan scourers. • Clean the hob, when it is cool, after each use in order to remove any food residues. • Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed. • Salt, sugar and sand can scratch the glass surface. [. . . ]