User manual WHIRLPOOL ETP 8460/IN INSTRUCTION FOR USE

[. . . ] This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. Yes Yes Yes Yes Yes L L L L L — — — — L — L L L L — L L L — — L L L L L L — — — L — — — — — — — L L — L — — — — — — — — — — — — L L — — L L L L L L — L L 800 1) 800 1) Max. Max. Lingerie — — 2. 5 Curtains and delicate clothing in wool or silk only washable in cold water. Quickwash 35 °C 2. 5 Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends. Dailywash 40 °C 3. 5 Slightly to normally soiled garments made of cotton and/or synthetics. Cold wash — — 5. 0 Slightly soiled garments in cotton and/or synthetics washable only in cold water. Drying 30 °C 3. 0 Drying can be carried out using the “Cotton“ programme (with dry laundry load of 3 kg) or the “Synthetics” programme (with dry laundry load of 1. 5 kg). — Max. Max. Rinse — — 5. 0 Same as the last rinse and the final spin in the “Cotton” programme. Drain/Spin — — 5. 0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. L: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. The “wool” programme of this washing machine has been approved by The Woolmark Company for the washing of garments labelled as “machine washable”. [. . . ] Open the water tap; Turn the programme selector to “Off/0” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. “Door open” indicator Lighting up of the indicator could be caused by the door not being properly closed. Turn the programme selector to “Off/0” and reset the programme. If the indicator remains on, refer to the “Troubleshooting Guide” in the Instructions for Use. PROGRAMME END ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in the Instructions for Use. Turn the programme selector to the desired programme. The indicator of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button. SELECT ANY DESIRED OPTION • Press the “Start Delay” button to select programme start a delay time of 1 to 12 hours; • Press the “Start” button. The indicator next to the “Start Delay” button lights up, whereas the selection indicator flashes to signal the countdown of the remaining time. • At the end of the delay time the machine starts the set programme. The LED indicating the wash stage in progress lights up. • After pressing the “Start”, the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. To cancel the “Start Delay”: Press the “Start Delay” button until all the indicator lights are off. PROGRAMME START Open the tap and press the “Start”. The indicator next to the “Start” button lights up. The programme sequence indicator shows the current programme stage, running from left to right through Prewash/Wash, Rinse, Spin/Drain, End. “DOOR OPEN” INDICATOR • Lighting up of the lamp on the wash sequence indicator means that the programme has ended and the door is unlocked. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGING PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Turn the programme selector to “Off/O”. Select the new programme, any options and another spin speed if you want. [. . . ] Note: The programme stops to “Rinse hold” at the time the “Rinse Hold” light in the programme sequence indicator is on. The indicator next to the “Start” button flashes. To terminate the “Rinse hold” option: • Press the “Start” button; the programme will terminate automatically with the final spin cycle for the preset wash programme. “Variable spin” button • Every programme has a predefined maximum spin speed. [. . . ]