User manual WHIRLPOOL ETV 5660 IN BK PROGRAM CHART

[. . . ] Power indicator • • • • To use the hob, turn the knob(s) clockwise and set it/them to the required power. To turn the hob off, turn the knob(s) back to position “0”. Indicators light up progressively to show the power selected. The hob is fitted with a residual heat indicator. [. . . ] • Do not use abrasive products, chlorine-based cleaners, oven-cleaner spray or pan scourers. • The hob should be treated periodically with specific products available from the shops, following the manufacturer's instructions. • • To switch off the dual zone function, turn the knob to . Important: To avoid permanently damaging the glass-ceramic top, do not use: - Pots with bottoms that are not perfectly flat. - Metal pots with enamelled bottom. Energy saving • • • • • • • Use pots and pans whose bottom diameter is equal to that of the cooker plates, or slightly larger. If possible, keep the pot covered when cooking. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. DIMENSIONS OF COOKING HOB AND WORKTOP (mm) Make sure that the voltage indicated on the rating plate is the same as the mains voltage. Technical data is given on the rating plate on the edge of the hob and also below: Telescopic knobs (depending on model) CAUTION ELECTRICAL CONNECTIONS Supply voltage 230 V ~ 230 V 3 ~+ 400 V 3 N ~ + 400 V 2 N ~ + Cables (number and size) 3 x 2, 5 mm2 4 x 1, 5 mm2 5 x 1, 5 mm2 4 x 1, 5 mm2 • • • • • • • Type PLEVL 230 V~/400 V 3 N~ 50 Hz 6, 8 kW • • The knobs can be lifted approx. • After cleaning, restore the knob to its original position. Should the hob become cracked or broken, do not use TROUBLESHOOTING GUIDE it and call the After Sales Service immediately. The hob does not work: If the hob incorporates halogen cooking elements, do - Make sure that the power supply is on. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. 3. Preparing the housing unit Cut the worktop to fit before installing the appliance. Carefully remove any shavings or sawdust that could prevent the appliance from running properly. Attention: to install the hob on other surfaces than wood (marble, plastic, ceramic, marble, stone, etc. ) remember to ask After Sales Service for the fixing plates (fig. • The hob must be fitted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm. • Insert a separator panel at a minimum distance of 90 mm from the bottom of the hob, so that it cannot be accessed by the user. • If there is an oven under the hob, make sure that it is manufactured by us and equipped with a cooling system. • There must be nothing between the hob and the oven (e. g. • An adjacent column unit must be installed at least 100 mm from the edge of the hob. [. . . ] The oven power cable must be long enough to connect the built-in appliance to the mains. Observance of safety directives requires that a multipole switch with a minimum contact gap of 3 mm be used for the installation. Do not use multiple plug adapters or extension leads. After the oven has been installed, the electrical components must be inaccessible. Fig. [. . . ]