User manual WHIRLPOOL EV 1288 PRODUCT FICHE

[. . . ] Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc. ). Machine washable woollens with pure new wool label. If the “Rinse Hold” option is selected don't leave the wash to soak for too long. This programme allows starch or softener to be added. [. . . ] Alternative way to end programmes after a “Rinse Hold”. Detergents and additives Prewash Main Wash Softener Bleach Options Rinçage Intensif Intensive Rinse Arret cuve pleine Rinse Hold 5. 0 5. 0 2. 0 5. 0 2. 0 5. 0 5. 0 1. 5 1. 0 1. 5 1. 5 — Yes 1) — 1) — 1) — 1) — 1) — 1) — 1) — 1) — 1) — 1) — 1) — 1) Yes Yes Yes Yes Yes — — h h h h h h — h h — — — — — — — — — — h h h h h — — — — — — — h h h h h h — from “Froid” to 90 from “Froid” to 90 from “Froid” to 60 from “Froid” to 40 from “Froid” to 40 “Froid” — from “Froid” to 40 from “Froid” to 30 “Froid” — — 1000 1000 1000 1000 500 2) 1000 1000 400 3) 400 3) 400 3) 400 3) — 130 115 100 85 70 20 15 55 45 15 10 5 Yes Yes — — — h h h — — h — h — — N. B. Please avoid excessive detergent dosing. 5019 612 10028 Programme ENERGY AND WATER CONSUMPTION DATA Temperature Load Water Energy (°C) 90 60 60 40 40 40 40 40 (kg) 5. 0 5. 0 2. 0 2. 0 2. 5 2. 0 1. 5 1. 0 (l) 72 64 56 56 54 54 70 70 (kWh) 1. 80 1. 20 0. 80 0. 40 0. 50 0. 40 0. 65 0. 55 Programme time (min) 115 115 100 100 85 70 55 45 Cotton + Intens. Rinse Cotton Coloured Coloured Quick Wash Synthetics Delicate Wool Terminate the “Rinse Hold” option. • Press the “Rinse Hold” button again; the programme will terminate automatically with the spin cycle corresponding to the previously selected wash programme. • If you do not wish to spin the clothes, switch off the appliance by pressing the “On/Off” button. Turn the programme selector to the “Drain” position and switch on the appliance. PROGRAMME START Open the water inlet tap and press the “On/Off” button. DOOR LOCK During the running programme, the door cannot be opened. The door locks automatically in all programmes. • At the end of the spinning cycle the drum goes on reversing for some minutes: this helps you unloading the laundry. • Do not exceed in detergents dosage: excessive foam formation may prevent spinning. • Your imbalance detection and correction system reduces spin speed or interrupts the spin automatically in case of imbalance load – see “Troubleshooting guide”. • Your machine has a new, electronically-controlled motor: don’t be surprised by its sound. • If you want to change the programme during the wash cycle, remember to switch the machine off before turning the programme selector knob. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. [. . . ] * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. PREPARATION OF WASH CYCLE 1. Close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. [. . . ]