User manual WHIRLPOOL EV 7642 PROGRAM CHART

[. . . ] in hard wearing and high temperature resistant cotton. The maximum load for heavily soiled washing is 3. 5 kg. Moderately soiled sheets, tablecloths, underclothes, towels etc. [. . . ] Alternative way to end programmes with a “Rinse Hold” setting. 5. 0 Yes Yes °C rpm/min 750 rpm/min 750 min (2) 130 ❉ ❉ ❉ — ❉ ❉ — — — — — — — — — — ❉ ❉ ❉ ❉ ❉ ❉ — — — — — — ❉ ❉ ❉ ❉ ❉ ❉ — Cold to 90 5. 0 2. 0 5. 0 2. 0 5. 0 5. 0 1. 5 1. 0 5. 0 1. 5 — — — — — — — — — — — Yes Yes Yes Yes Cold to 90 Cold to 60 Cold to 40 Cold to 60 Cold 750 750 750 750 750 750 600 1) 600 1) 600 1) 600 1) 750 500 to 750 500 to 750 500 to 750 500 to 750 500 to 750 100 to 450 100 to 450 100 to 450 100 to 450 115 100 85 70 20 10 55 45 15 5 3 ❉ ❉ — — — Yes Yes — Cold to 40 Cold to 30 Cold ❉ ❉ ❉ — — ❉ ❉ ❉ — — — — — — — — — — N. B. : The excess of detergent in the dispenser could cause technical problems. 5019 100 12653 GB ENERGY AND WATER CONSUMPTION DATA Programme Temperature selector (°C) 90 60 60 60 40 30 40 40 Load (kg) 5. 0 5. 0 2. 0 2. 0 2. 5 1. 5 1. 5 1. 0 Water (l) 72 69 66 54 49 45 70 70 Energy (kWh) 1. 80 1. 15 0. 80 0. 40 0. 50 0. 30 0. 65 0. 55 Programme time (min) 115 115 100 100 85 70 55 45 Cotton Cotton Coloured Coloured Rapid + 1/2 Load Synthetics + 1/2 Load Delicate Wool “Rinse Hold ” button • The laundry remains in the last rinse water without progressing to spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programme “Synthetics” or “Delicate”. • This option is perfectly suitable if you wish to postpone the spin or you don’t wish to spin the washing. Note: the programme selector stops on “ ”. Terminate the programme • Press the “Rinse Hold” button again; the programme will terminate automatically with the spin cycle corresponding to the previously selected wash programme. • If you don’t wish to spin the clothes, switch off the appliance by pressing the “On/Off ” button. Turn the programme selector to the “Drain” position and switch on the appliance. Programmes with pre-wash last about 15 minutes more than programmes without pre-wash. Water and energy consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual consumption may vary in comparison with the values specified in the table, because of differences in supply water pressure and temperature, the load and the type of wash. PROGRAMME START Open the tap and press the “On/Off ” button. The pilot lamp lights up. DOOR LOCK During the running programme the door cannot be opened The door locks automatically during all programmes. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents Anti-scale agents (water hardness 4) • Important Note: • Be careful not to fill more than the “MAX” level mark. • For programme with prewash: do not use liquid detergent. • For programmes without prewash from cold to 40° C, it is recommended to use a liquid detergent to avoid white traces on coloured washing. PROGRAMME END • 1. The programme selector knob is at “Stop”. Cancel the options by pressing the corresponding buttons. [. . . ] Only open the door when the programme selector is at “Stop” and the door is unlocked (after approximately 1 minute). CLOSE THE DOOR AND SELECT THE PROGRAMME 1. Turn the programme selector knob Turn the temperature selector knob Turn the spin speed selector knob to the desired programme. to the desired speed. TO STOP, RESET A PROGRAMME BEFORE THE END 1. [. . . ]