User manual WHIRLPOOL EV 840 INSTRUCTION FOR USE

[. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Slightly to normally soiled textiles made of cotton and/or synthetics. Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Drain only - no spinning. Programme Care Labels Coton 95°C Coton 40 - 60 - 95°C Synthétique 60°C Synthétique 30 - 40 - 60°C Délicat 30°C Rapide 30min. Laine Froid - 40°C Detergents and Additives PreMain Softener wash Wash Special options Start Spin speed Delay reduction Départ Essorage différé 400 trs i 1) i 1) i 1) i 1) i 1) i 1) i 1) i 1) i 1) i i i i i i i i i i i i – i i i – Max. Spin Speed rpm 800 800 800 800 800 800 800 800 400 2) 800 800 800 – Cotton with prewash 95 °C Cotton 40 - 60 - 95 °C Synthetics with prewash 60 °C Synthetics 30 - 40 - 60 °C Delicates 30 °C Quick wash 30 °C Wool Cold - 40 °C Daily load 40 °C Handwash 30 °C Rinse & Spin Spin Gentle Spin Drain 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 3. 0 1. 0 – – – – 5. 0 5. 0 1. 0 – Yes – Yes – – – – – – – – – – Yes 1) i i i i i i i i i i – – – Yes Yes 1) Yes Yes Yes Yes Yes Yes – – – – 40°C Lavage main 30°C Rinçage & Essorage Essorage Essorage court Vidange N. B. Please avoid excessive detergent dosing. Laden is a registered trademark of Whirlpool USA. 5019 612 10117 CONSUMPTION DATA Temperature Programme Cotton Cotton** Cotton Synthetics Synthetics Delicates Quick wash Wool Daily load Handwash (°C) 95 60 40 60 40 40 30 40 40 40 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 3. 0 1. 0 (l) 50* 50 55 50* 45 50 35 55 40 40 (kWh) 1. 70 0. 95 0. 55 0. 80 0. 45 0. 55 0. 40 0. 55 0. 45 0. 40 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:10 2:00 1:30 1:15 0:45 0:30 0:45 1:00 0:35 Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap: if the indications still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. [. . . ] PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Open lid and drum and unload the machine. Leave the lid open for some time to allow the interior of the machine to dry. [. . . ]