User manual WHIRLPOOL EV180NZBQ DIMENSION GUIDE

[. . . ] Plan the Installation Plan your installation using these instructions in conjunction with the Use & Care Guides provided with the refrigerator and freezer. IMPORTANT: For ease in handling and alignment, it is recommended that two people install the trim kit. Make sure there is enough area, approximately 7 ft (2. 1 m) to assemble parts on the Lay a drop cloth on the the to cushion the parts and cover A B C D E These instructions are intended as a general guide only and do not supersede any national or local codes in any way. [. . . ] aSSEMBLY INSTRUCTIONS Assemble the Top Grille 1. Assemble the six grille extrusions by sliding one into the other through the tongue and groove feature as shown. Align the hole on the side extrusion with the groove on the top extrusion on each side of the grille assembly. Using the two countersunk Phillips screws, fasten the side trim to the grille assembly. Insert the screw through the predrilled hole and into the groove on each side of the grille assembly as shown. â³â„₈" (9. 5 mm) 4 INSTALLATION INSTRUCTIONS Install the Top Grille and Trim Assembly IMPORTANT: The top grille and trim assembly, and your floor can be damaged if the assembly is dropped. Place cardboard or hardboard over the floor at each side of the rough opening where the side trim will meet the floor. Place the top grille and trim assembly face down on the floor centered in front of the rough opening. Using two people, one on each side, lift the trim assembly and position it into place above and on each side of the opening. Using a carpenter’s level, level the top trim, and shim as necessary. Adjust the leveler legs so that each appliance is level and plumb and at the same height as the other appliance. NOTE: The freezer and refrigerator each have two front leveler legs that are adjustable. The back of each cabinet rests on two fixed supports. Check the level first side to side and then front to back. To raise a corner - Turn the leveler leg clockwise. To lower a corner - Turn the leveler leg counterclockwise. electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Check the level of the appliance since it may have changed when you moved it into the opening. Attach the plastic foam spacer, to the side of the appliance, so that it is flush with the top and rear edge of the cabinet as shown. NOTE: The spacer ensures that the two appliances are positioned the correct distance apart from each other. [. . . ] Install the Base Grille Install the Bracket onto the Cabinets 1. Remove the plastic base grille from each appliance. The four " hex head screws contained in the kit, will be used to fasten the bracket. Insert one screw through the lower bracket and thread it into the cabinet. [. . . ]