User manual WHIRLPOOL EXCELLENCE 4480 PROGRAM CHART

[. . . ] Select spin speed according to the manufacturer’s recommendations on the care label. Normally to heavily soiled and robust white cotton laundry. Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, in addition to your detergent. White and pastel shaded garments made of delicate fabrics. [. . . ] The programme sequence indication shows the current programme phase, running from left to right through wash, rinse, spin, drain. In some phases, the remaining programme time is newly calculated If this is the case, the on the display will fade, and the remaining time is replaced by an animation. CHILD LOCK Activating the child lock prevents children from starting a wash cycle or changing the settings of a running programme. The child lock cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press the 2 buttons marked with the key symbol simultaneously for a few seconds. The “Child lock” symbol will shortly blink and then light up to indicate that the child lock is active. The programme setting cannot be changed anymore. The only change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock, proceed in the same way as for activating it. SET A START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the Start delay button to select a delay time up to 23 hours. • Press the “Start (Pause)” button . The clock symbol next to the delay time and the colon between hours and minutes blink. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • If you use the “Dosing Aid” button: select the delay time BEFORE pressing the “Dosing Aid” button. The countdown of the selected delay time begins after having pressed the “Start (Pause)” button for the second time (see separate Instructions for Use concerning the “Dosing Aid”). To cancel the “Start delay” . . . before you press the “Start (Pause)” button: • Press the “Reset/Drain” button , or set the start delay time to “0:00” - the delay time disappears after a few seconds. . . . after having started the programme: - Press the “Start (Pause)” button - the delay time disappears from the display. Press “Start (Pause)” again to start the selected programme immediately. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). [. . . ] Press the “Start (Pause)” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. Press the “Start (Pause)” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]