User manual WHIRLPOOL FGZ 5402 AR PROGRAM CHART

[. . . ] The manufacturer cannot be held responsible for damage which arises from unreasonable, incorrect or rash use of the appliance. 23 TIPS FOR THE USER  During and immediately after use some parts of the hob can reach very high temperatures.  Keep children away when the hob is in use.  After using the hob make sure that the knob is turned off and turn off the main tap of the gas supply pipe or the cylinder tap.  When you are not using the hob it is a good idea to turn off the gas supply tap. [. . . ] Choose the suitable burner depending on the cookware diameter and capacity. The pan diameter should be suitable for the burner power to make the most of the burner's high efficiency and not waste fuel. A small pan does not boil more quickly on the large burner. PAN DIAMETER BURNER Auxiliary Medium-speed Rapid MINIMUM 6 cm 16 cm 20 cm MAX. 14 cm 20 cm 24 cm do not use pans with concave or convex bases Attention: During use the hob becomes very hot under the cooking zones. 4 27 CLEANING AND MAINTENANCE GENERAL TIPS  Before cleaning the hob switch it off and wait for it to cool down.  Clean with a cloth wetted with hot water and soap or water and liquid detergent.  Do not use products which are abrasive, corrosive or chlorine based or steel pads.  Do not leave acid or alkaline substances (vinegar, salt, lemon juice, etc. ) on the hob. BURNERS AND GRIDS  These pieces can be removed and washed with suitable products.  After cleaning burners and spreaders dry them well and replace them correctly.  In appliances with electric ignition keep the electrode clean so that the sparks always strike.  Note: To avoid damage to the electric ignition do not use it when the burners are not in place. ENAMELLED PARTS  All the enamelled parts must be washed only with a sponge with soapy water or other non-abrasive products.  If an oven and hob are being installed (which is thus possible) the distance between the two appliances must be at least 30 mm. Work downstream of the gas mains independent connections. Fig. 8 650 mm 31 INSTALLATION INSTALLATION ON UNITS WITH DOORS (fig. 9 ;;;;;;; Depression space Door Space for connections MOUNTING THE FASTENING TABS (fig. 10)  Each hob is supplied with a set of tabs and screws to fasten it to units from 2 to 4 cm thick.  Turn the hob over and put tabs "A" into the mountings; only tighten screws "B" a few turns.  Make sure that the tabs are mounted correctly as shown in Figure 10. FASTENING THE HOB (fig. 10)  Stretch gasket "C" above the unit along the edge of the hole made, being careful to overlay the joining edges.  Put the hob into the hole cut into the unit and position it correctly.  Put tabs "A" into place and tighten screws "B" until the hob is completely secured.  Using a sharp tool cut off the part of the gasket which sticks out from the hob. [. . . ] It is recommended that it be replaced whenever it shows even the slightest deformation or imperfection.  After connecting to the mains, check that the couplings are correctly sealed, using soapy solution, but never a naked flame. C F A 1/2” G conical Fig. 14 35 GAS MAINTENANCE If the burners do not work properly replace the injectors and set the minimum as described below. Fig. 15 J REPLACING THE BURNER INJECTORS Injectors can be obtained from the AfterSales Service Centres. [. . . ]