User manual WHIRLPOOL FL 800 INSTRUCTION FOR USE

[. . . ] 6gb10005. fm5 Page 17 Saturday, June 1, 2002 11:42 AM CONTENTS BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES LIQUID BLEACH (HYPOCHLORITE) DYEING WASHING PROGRAMME REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION 6gb10005. fm5 Page 18 Saturday, June 1, 2002 11:42 AM BEFORE USING THE WASHING MACHINE 1. Removing the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. 6. Electrical connections • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. [. . . ] In case of interrupted electricity do not open the door, because hot water could be released from the appliance. Programme end The programme selector knob is at the stop position. 1. Press the “On/Off” button. 2. Cancel the special options by pressing the appropriate buttons. 4. Wait for the door to unlock (about one minute). Do not fully close the door but leave it ajar to allow the drum to dry out. Changing programme 1. Press the “On/Off” button. For this programme do not add any further detergent. Changing options The options can be selected or deselected without switching off the appliance. Programme interruption or pause To interrupt the running programme for a certain period and continue it at a later time: 1. Press the “On/Off” button. Following the desired pause press the “On/Off” button once again. Cancelling the programme If the current programme is to be terminated prematurely and cancelled, the water must be pumped out first before the door can be opened: 1. Press the “On/Off” button to switch off the appliance. Set the programme selector to programme setting “Drain”. Press the “On/Off” button in order to start the “Drain” programme. 24 6gb10005. fm5 Page 25 Saturday, June 1, 2002 11:42 AM REMOVING THE FILTER 1. Switch off the appliance and drain the water (see next paragraph “Draining residual water”). Place a tray or container beneath the cover. Slowly turn the filter anticlockwise without unscrewing it completely (using pliers to handle the filter grip makes screwing easier). Wait until all the water has drained off. Now unscrew the filter completely and remove it. Remove any foreign material from the filter. Insert the filter and screw it in clockwise firmly until it locks. Pour 1/2 litre of water into the detergent drawer and check that water does not leak from the filter. Check the filter two or three times a year and clean it if necessary. • Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. • Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc. ). IMPORTANT: Make sure the water has had time to cool before draining the appliance. 2 6 4 DRAINING RESIDUAL WATER 1. Switch off the appliance. [. . . ] If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). Periodically check the hose for brittleness and cracks and replace if necessary. The appliance can be connected without an anti-backpressure valve. A For models with Water Stop hose “B” If the flexible hose is damaged, unplug the appliance from the mains immediately. 1. Screw the threaded connector with the filter inserted onto the tap. [. . . ]