User manual WHIRLPOOL FL 811 PROGRAM CHART

[. . . ] The hob is provided with 2 indicator lights showing when the cooking zones are hot. These indicator lights switch on as soon as the cooking zones reach a high temperature. These indicator lights remain on even after switching off the relevant cooking zone and they switch off only when the temperature of the cooking zone is no longer dangerous. Important: To avoid permanently damaging the glass ceramic top, do not use: - pots with bottoms that are not perfectly flat, - metal pots with enamelled bottom. ELECTRICAL CONNECTION Power supply voltage 230 ~ + Number of wires x dimensions HO5 RR-F 3 x 1. 5 mm2 • • • • • • • • Energy saving Use pots and pans whose bottom diameter is equal to, or slightly larger than, that of the cooking zones. [. . . ] Use pans whose bottom diameter is equal to, or slightly larger than, that of the hotplates/ cooking zones. BEFORE USING THE COOKING HOB Before use, remove: - adhesives stuck on the hob; - cardboard guards and protective plastic film; - check whether the hob has been damaged during transport. If in doubt, contact the After Sales Service. DIMENSIONS OF COOKING HOB AND WORKTOP (mm) Knob (1-6) 1-2 2 3 3-4 4 4-5 6 Table for using the cooking zones Melting butter, chocolate, etc. Keeping food warm and reheating small quantities of liquid Heating larger quantities, making custards and sauces Gentle simmering, for example: boiled vegetables, spaghetti, soups, pot roasts, stews For all fried food, cutlets, steaks, cooking without use of lid, for example: risotto Browning meats, roast potatoes, fried fish and to boil large quantities of water Brisk frying, griddling steaks, etc. Knob (1-12) 1-2 2-3-4 4-5-6 6-7 7-8 8-9-10 11-12 CARE AND MAINTENANCE Important: never clean the appliance with high pressure water or steam cleaning equipment. • Clean the hob, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. • Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specific glass ceramic cleaner. • Remove baked-on dirt with the special scraper tool (if provided) and specific cleaning products. • Food spills should be cleaned off before they bake onto the glass ceramic surface. • Do not use abrasive products, chlorine-based cleaners, oven-cleaner spray or pan scourers. • The hob should be treated periodically with specific products available from the shops, following the manufacturer's instructions. WARNINGS • • • TROUBLESHOOTING GUIDE The hob does not work: - Check for the presence of mains electrical power. - Switch the hob off and then back on again, to see if the problem has been solved. - Make sure that the knob is not turned to “0”. Turn the multi-pole switch to “Off” for a few minutes and then turn it back to “On”. Type PLAVD 230 V~/50 Hz 2. 80 kW 5019 619 01061/A To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. AFTER SALES SERVICE Before contacting After-Sales Service: • Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide“. If after the above checks the fault persists, contact the nearest After Sales Service. Please give: • a brief description of the fault; • the type and exact model of the hob; • the service number (i. e. , the number that follows the word SERVICE on the rating plate, located under the hob). The service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Declaration of conformity • • This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. This cooking hob has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous. • ACCESSORIES The glass cover can be ordered via the After Sales Service, with the code: AMC 966 NB (New Black) AMC 966 MR (Mirror). This cooking hob has been designed, constructed and marketed in compliance with: - safety objectives of the “Low Voltage” Directive 2006/ 95/CE (which replaces 73/23/CEE and subsequent amendments); - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. • All electrical connections must be made before connecting the appliance to the power supply. [. . . ] • Close the cover of the terminal board. • After the electrical connection, fit the hob from the top and hook it to the fixing springs, as shown in fig. 1 Glass ceramic hob Important: remove any protective film before installing the hob. Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range. [. . . ]