User manual WHIRLPOOL FUN 630 AL INSTRUCTION FOR USE

[. . . ] GB CONTENTS PAGE BEFORE USING THE DISHWASHER PROTECTING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS CONNECTIONS ELECTRICAL CONNECTION HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER CARE AND MAINTENANCE 11 11 11 12 13 14 15 16 17 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE To make the most of your new dishwasher, please read these user instructions and the quick reference guide carefully. 10 BEFORE USING THE DISHWASHER 1. Removing the packaging and check After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. Keep the packaging materials (plastic bags, etc. ) out of children's reach, as they are potentially dangerous. [. . . ] The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. In this case, the wire which is coloured GREEN AND YELLOW must be connected to the EARTH contact, and the two wires to the two pins, irrespective of colour. The supply to the socket must be fitted with a 16 amp fuse. Connection to a rewirable plug If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere. A suitable alternative plug should then be fitted to the cable. 13 HOW TO FILL THE SALT CONTAINER To ensure the dishwasher works at its best, soft water, i. e. The presence of lime in tap water causes water stains due to calcium deposits on crockery and glasses. A water softening system has been built in the dishwasher to ensure a steady supply of soft water. This is basically a decalcifying system, which needs to be regenerated regularly using special dishwasher salt. Setting the correct water hardness level: Set the water hardness level by turning the selector fitted on the left-hand side of the inner appliance wall by using a coin. Use the table below to set the dial to the correct setting: Water hardness category 1 2 3 4 German degrees °dH 0-6 7 - 13 14 - 20 21 - 35 French degrees °fH 0 - 11 12 - 23 24 - 36 37 - 63 Position of the selector 0 1 2 3 If the water hardness level falls within category 1 (soft), no salt is required. To find out the waterhardness level of water in your area contact your local Water Board or check the last bill you received. If provided, a simple test can be employed to set the hardness level using the hardness test strip. • Dip the test strip into a glass of water from the tap. • Wait for 3 seconds, withdraw the strip from the water. • If all the three test squares are still green, set the hardness selector to 0, and disregard all instructions about salt usage. • If one of the test squares becomes red, set the selector to 1. • If two of the test squares become red, set the selector to 2. [. . . ] add rinse aid. 'DUN VXIILFLHQWULQVHDLG Check the rinse aid level regularly. Additional electric indicator (if provided): The indicator lamp on the control panel lights up when more rinse aid needs to be added. /LJKW DGGULQVHDLG 15 HOW TO FILL THE DETERGENT DISPENSER A small compartment (A) and a large one (B) are provided for the detergent. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies for different brands. [. . . ]