User manual WHIRLPOOL G2P DWI / WH PROGRAM CHART

[. . . ] One of the programme indicator lamps will switch on. Press the programme selector button until the corresponding indicator lamp switches on. If necessary, select options (if supplied). Press the Start button to start the selected programme. [. . . ] Load cups at an angle to facilitate water drainage. In general, place the cutlery in the basket with the handles positioned downwards. but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not impeded by crockery or cutlery. Switch off the dishwasher: once the “Start” indicator lamp has switched off. If the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. • Have you selected the correct programme?• Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). • Are the filters clogged or incorrectly assembled?(See “Care and Maintenance” chapter in the user instructions). • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted?• Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). [. . . ] Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted). • Is the flow of water obstructed by impurities? [. . . ]