User manual WHIRLPOOL GBS279PVS INSTALLATION INSTRUCTION 4-08

[. . . ] Given dimensions provide minimum clearance with oven. Phillips screwdriver Measuring tape Hand or electric drill (for wall cabinet installations) 1" (25 mm) drill bit (for wall cabinet installations) Level Recessed installation area must provide complete enclosure around the recessed portion of the oven. 6 cm) maximum below the support surface when the oven is installed in a wall cabinet. 5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. [. . . ] Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. To avoid floor damage, set the oven onto cardboard prior to installation. Do not use handle or any portion of the front frame for lifting. Remove and set aside racks and other parts from inside the oven. Move oven and cardboard close to the oven's final location. NOTE: Screws for attaching side trims (after oven is installed in cabinet) are in a screw bag inside the package containing literature. Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. Failure to follow these instructions can result in death, fire, or electrical shock. This oven is manufactured with a neutral (white) power supply wire and a cabinet-connected green (or bare) ground wire twisted together. Feed the flexible conduit from the oven through the opening in the cabinet. Route the flexible conduit from the oven to the junction box through a UL listed or CSA approved conduit connector. See "Electrical Connection Options Chart" to complete installation for your type of electrical connection. Untwist white wire from green (or bare) ground wire coming from the oven. Connect the 2 white wires (F) together using a UL listed wire connector. Connect the green (or bare) ground wire (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. If your home has: 4-wire Go to section: 4-wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U. Where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. Green (or bare) ground wire (from oven) Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector. [. . . ] Push hinges in as far as they will go and open the oven door. You should feel the oven door drop into place. Rotate both hinge latches back to the locked position. If it is not, repeat the removal and installation procedures. [. . . ]