User manual WHIRLPOOL GCFP 4824 WH INSTRUCTION FOR USE

[. . . ] When the button is pressed, (12) lights up. Wait for two seconds to view the full display on the screen after you turn on the machine by pressing the On/Off button (1) before you press Start / Pause / Cancel (2) button. If you want to change running program, first of all press Start / Pause / Cancel button (2) to switch your machine into pause mode. Second, switch to the desired program by pressing Program Selection button (4). Third, Start the new program by pressing Start / Pause / Cancel button (2) again. [. . . ] The delayed start indicator sand glass (13) and play icon (12) will remain lit on the display during the delayed start countdown and the delay time indicator (11) will display the remaining time. Program will start automatically when the countdown is over. You can use the delayed start function if you are utilizing the economic electricity tariff. If you want to change the program or functions while the delayed start function is enabled, then pause the machine by pressing the Start / Pause / Cancel button (2). The delayed start indicator will start flashing. Select the new program and/or add the functions as described in Program Selection and Table of Average Consumption Values. Resume the delayed start countdown by pressing the Start / Pause / Cancel button (2). If you want to cancel delayed start countdown while it is in progress, then press the Start / Pause / Cancel button (2) for three seconds. Release the button when symbols (12) start flashing in the display. For a couple of minutes the machine will fulfill the necessary operations required for cancellation. Remaining time indicator (11) displays “0:00”. Keep Half Load button (5) pressed for three seconds more. Rinse Aid Indicator (10) comes on and the stored rinse aid indicator status of your machine appears on the display in the format of “ON” or “OFF”. You can change the status of the indicator as “ON” or “OFF” with Start / Pause / Cancel button (2). If you switch off the machine with “On/Off” button (1) when the status is “ON”, then the rinse aid indicator will come on when the rinse aid level in your machine becomes low while the machine is in use. If you switch off the machine with “On/Off” button (1) when the status is “OFF”, then the rinse aid indicator will never come on. Plug the mains plug into the wall socket. Check if the upper and lower impellers rotate freely. Put sufficient amount of detergent in the detergent dispenser and close its lid. Check if the salt and rinse aid warning indicators (9, 10) light and add salt and/or rinse aid if needed. Determine your washing program with the aid of the Program Data and Table of Average Consumption Values. You can select the determined washing program by pressing program selection button (4). You can see the program time in the Remaining Time Indicator (11). [. . . ] Turn off your machine by pressing On / Off button (1). Unplug the mains plug from the wall socket. Leave your dishes in the machine for about 15 minutes after they are washed in order to have them cooled down. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. [. . . ]