User manual WHIRLPOOL GCFS 4522 WH INSTRUCTION FOR USE

[. . . ] The maximum temperature allowed for the inlet hose is 60°C. • When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from the sink siphon). • Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation. • For appliances with waterstop system only: If the water connections are made correctly, the water-stop system safeguards your home against damage caused by flooding. [. . . ] • Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations: • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it: the appliance may topple over!• Do not use solvents inside the dishwasher: risk of explosion!• Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers. • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • If necessary, the power cable may be replaced with another of the same kind obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. • On completion of the programme switch off the dishwasher and turn off the water tap. For appliances with water stop system, this operation is not necessary. The float lowers and is no longer visible when the salt container is empty. Salt level indicator: The dishwasher is equipped with an electric or visual salt level indicator (depending on the model installed). 16 496gb94500. fm5 Page 17 Wednesday, July 4, 2001 11:19 AM How to fill the rinse aid dispenser The rinse aid facilitates drying and prevents the formation of unsightly spots and streaks on crockery. Before using the dishwasher for the first time, fill the rinse aid dispenser. Only use rinse aids recommended for use in domestic dishwashers. Fill the dispenser with rinse aid until the level indicator becomes dark. Immediately wipe away any rinse aid spilt accidentally!This prevents the formation of excess suds which may spoil washing results. Close the cover. How to adjust the rinse aid dosage regulator: Factory setting: position 4. If you are not satisfied with washing or drying results, change the rinse aid dosage setting. Thereafter, regularly check the rinse aid level. 1. If crockery is prone to whitish streaks: reduce the dosage by turning the dial to a lower setting (-) using a coin or the like. If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (+). [. . . ] The fixing nut must be tightened until it clicks!Cleaning the inside of the dishwasher: Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residue. Upper spray arm: 1. Slacken the fixing nut (by turning it counter-clockwise) and detach the spray arm by pulling it down. Remount the spray arm by aligning it with the rotary mounting. Lower spray arm: 1. [. . . ]